Use Of Variator; Stop/My Button; Saving Or Modifying The Favorite Position (My); Replacing The Batteries - SOMFY Ysia 5 Variation Zigbee Instructions Manual

EN

3.2.Use of Variator

NOTICE
The use of this dimmer button depends on the products associated in the same channel.
With TaHoma ready:
NOTICE
In this mode, light and heat receivers are not supported.
▪ scroll the variator step-by-step to adjust the tilt of the slats.
▪ scroll the variator a few turns to the right or a few turns to the left, the
motorised product goes up or down to the up or down end limits.
With TaHoma switch:
NOTICE
• Ysia 1 Variation Zigbee is not compatible with TDBU motorised products.
• With supporting products other than Venetians, roller shutters for example,
raising or lowering can be done step by step with the variator.
• In this mode, light receivers are supported.
• If using a light receiver, refer to the manufacturer's instructions.
▪ scroll the step-by-step the variator to adjust the tilt of the slats, the dimming
of the lighting or the heating.
▪ scroll the variator a few turns to the right or a few turns to the left, the
motorised product goes up or down to the up or down end limits. Lights and
plugs are switched ON or switched OFF.

3.3.Stop/my button

▪ Briefly press my to stop the motorised-product from activating.
▪ Briefly press my twice successively to move the motorised product to its
favorite position [see paragraph Saving or modifying the favorite position
(my)].

3.4.Saving or modifying the favorite position (my)

Place the motorised product in the desired position then press my for 5 seconds to
save or to modify the favorite position (my).

3.5.Replacing the batteries

DANGER
Read the Safety instructions document.
Explosion risk if the batteries are replaced by an incorrect type.
8
Ysia 1 Variation Zigbee
< 0.5 s
1]
2]
©
Copyright 2024 SOMFY ACTIVITES SA. All rights reserved.
Ysia 5 Variation Zigbee
< 0.5 s
< 0.5 s < 0.5 s
x2=
3]