Turning On The Ultralux Water Machine And Installation Inspection - UltraLux Water Machine Installation Manual

Turning on the UltraLux Water Machine
and Installation Inspection

Turning on the UltraLux Water Machine and Installation Inspection

1
2
Plug the Machine into a wall
power outlet. The Machine
will automatically flush for
approximately 30 seconds
through the drain line.
4
Once the 30 second, auto-
matic flush concludes, press
Flush button on the UltraLux
Water Machine to initiate a
manual flush cycle in the
Machine, lasting approxi-
mately 30 minutes.
NOTE: For additional information (Machine functions, display information,
troubleshooting, etc.) please refer to the included User Manual.
Slowly turn the cold waterline back on.
NOTE: If it is not already, turn the Diverter Valve into
the 'On' position. (See step 11 of the Source Water Set
Up)
Check for leaks around the Ports, located at the
back of the Water Machine.
3
Unscrew the Cap from the Faucet Data Line Port, discarding
the cap. Then plug the Faucet Power Cord into the Faucet
Data Line Port of the Machine, aligning the installation
notches. Tighten the Faucet Power Cord Nut.
5
Once the 30 minute flush cycle is complete, ensure that
water flows from the UltraLux Water Faucet both when the
handle is turned toward, and away, from yourself.
Check for leaks around all Quick Connects, the Diverter
Valve, and the Drain Clamp.
INSTALLATION INSPECTION CHECKLIST
19