Programmed Edit Recording - Aiwa XH-A1000 Operating Instructions Manual

PROGRAMMED EDIT RECORDING

CD EDIT/
CHECK
0-9,+10
DISC
DIRECT
PLAY
q
In the programmed edit recording function, the tracks can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
NOTE
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded on from the beginning of
either side.
Use the remote control from steps 3 to 8.
1 Load the tape into the cassette tray, and press
DOLBY NR to turn Dolby NR on or off.
Load the tape with the side to be recorded on first facing
upward.
2 Press CD and load the disc(s).
3 Press CD EDIT/CHECK twice.
The lines of PRGM EDIT and "PRGM" light up on the display.
PRGM
When "AI" is selected, press CD EDIT/CHECK again.
4 Press the numbered buttons 0-9 to designate the
tape length.
10 to 99 minutes can be specified.
Tape length
• f, g and MULTI JOG are also available to designate
the tape length.
22
ENGLISH
CD
c/d
f,g
s
PRGM EDIT
Maximum recording
time for side A
Tape side A
5 Press DISC DIRECT PLAY, then press one of the
numbered buttons 1-3 within 3 seconds to select
a disc. Then, press the numbered buttons 0-9 and
+10 to program a track.
Example : To select the 10th track of disc 2, press DISC
DIRECT PLAY and 2, then +10 and 0.
Selected track number
Program number
Selected disc
number
6 Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time
cannot be programmed.
7 Press CD EDIT/CHECK to select side B and
program the tracks for side B.
After confirming B on the display, repeat step 5.
Tape side B(reverse side)
8 Press qREC/REC MUTE, and then press
c/d within 2 seconds to start recording.
The tape is rewound to the beginning of the side facing
upward, the lead segment is played through for 10 seconds,
and recording starts. When recording on the side A facing
upward ends, recording on the other side B starts.
To stop recording
Press s. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK to select side A or B,
and press f or g repeatedly.
Track number
Program number
To change the program of each side
Press CD EDIT/CHECK to select side A or B, and press
sCLEAR to clear the program on the selected side. Then
program tracks again.
To clear the edit program
Press sCLEAR twice so that the line of EDIT disappears from
the display.
Remaining time on side A
Programmed track numbers
Programmed track numbers
Disc number