Advertisement
STAINLESS STEEL
DELUXE AREA HEATER
Model No. AH2069CS
12 Month commercial use warranty
1mm Emitter provides greater durability and heat performance
Durable #304 grade stainless steel body provides an attaractive,
clean finish with easier maintence when properly cared for, for
greater resistance against external elements
Electronic ignition for easy start-up with adjustable heat output
The ideal solution for extending the season of
outdoor entertaining
Creates a stylish and attractive ambience
Direct ignition
Includes a safety 'tip-over' switch that halts supply of
gas to the unit should it be accidently knocked over
Oxygen depletion system for enhanced safety
Stainless steel burner for extra long-term reliability
Complete with hose and POL regulator
Efficient and powerful 40MJ/h output
Adjustable heat output
Operates for approximately 9 hours on a properly
filled 9Kg Propane cylinder
For outdoor use only
Gas certified to Australian standards
FOR YOUR SAFETY
If you smell gas:
1. Shut off the gas to the appliance.
2. Extinguish any open flame.
3. If odour continues, immediately call your gas supplier.
Do not store or use gasoline or other flammable vapour
and liquids in the vicinity of this or any other appliance.
WARNING
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
Read the instructions thoroughly before installing or
servicing this equipment.
FOR OUTDOOR USE ONLY
PROPANE GAS
Important: Retain these instructions for future use.
04060 12/19
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Gasmate AH2069CS
Summary of Contents for Gasmate AH2069CS
- Page 1 STAINLESS STEEL DELUXE AREA HEATER Model No. AH2069CS 12 Month commercial use warranty 1mm Emitter provides greater durability and heat performance Durable #304 grade stainless steel body provides an attaractive, clean finish with easier maintence when properly cared for, for...
-
Page 2: Installation
Installation, Operation and Maintenance Instructions INSTALLATION Proper clearance from combustible materials must be Important Safety Rules maintained at all times. The minimum clearances are as follows: This appliance must only be used in a well ventilated Minimum Clearance from Combustibles: area. - Page 3 The hose must be protected from contact with hot or Any modification to the heater not described in the sharp surfaces both during use and while in storage. installation instructions may compromise the safety of this The hose assembly should be visually inspected prior appliance.
- Page 4 AREA HEATER ASSEMBLY Tools Required Phillips head screwdriver 2 Adjustable spanners Note: Remove any transit protection Burner head material assembly STEP 1 Secure the base to the cylinder house body with five M8 x 12mm long bolts. STEP 2 Secure the burner head to the inside of Electronic Ignition the cylinder house body with five M5 x (AAA Batteries not included)
-
Page 5: Leak Check
LEAK CHECK Leak Testing WARNING! This must be done before initial use, annually and whenever any components are replaced or serviced. A leak test must be performed annually and each Do not smoke while performing this test, and remove all time a cylinder is hooked up or if a part of the gas sources of ignition. - Page 6 AREA HEATER - For Outdoor Use Only Minimum Clearance from Combustible Surfaces*: 500mm 540mm *Combustible materials are considered to be wood, compressed paper, plant fibres, plastic or other materials that are capable of being ignited and burned.
-
Page 7: Troubleshooting
TEST FIRING HEATER Test fire heater, following the lighting instructions. Leak test all gas connections with soapy water. Soap bubbles indicate gas leakage. DO NOT use a match to test for gas leaks. WARNING: White smoke may appear around the radiant head during the first minute of the initial firing. TROUBLE SHOOTING Problem Possible Causes... - Page 8 SAFE APPLIANCE LOCATIONS This appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Any enclosure in which the appliance is used shall comply with the following: An enclosure with walls on all sides, but at least one permanent opening at ground level and no overhead cover (see Example 1).
Need help?
Do you have a question about the AH2069CS and is the answer not in the manual?
Questions and answers