Advertisement
Quick Links
COLUMN HEATER
Model No. CH205HTODS
The ideal solution for extending the season of
outdoor entertaining
Creates a stylish and attractive ambience
Rotary piezo ignition
Includes a safety 'tip-over' switch that halts supply of
gas to the unit should it be accidently knocked over
Oxygen depletion system for enhanced safety
Stainless steel burner for extra long-term reliability
Complete with hose and POL regulator
Efficient and powerful 35MJ/h output
Adjustable heat output
Operates for approximately 10 hours on a properly
filled 9Kg Propane cylinder
For outdoor use only
Gas certified to Australian standards
FOR YOUR SAFETY
If you smell gas:
1. Shut off the gas to the appliance.
2. Extinguish any open flame.
3. If odour continues, immediately call
your gas supplier.
Do not store or use gasoline or other flammable
vapour and liquids in the vicinity of this or any other
appliance.
FOR OUTDOOR USE ONLY
PROPANE GAS
WARNING
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
Read the instructions thoroughly before installing or
servicing this equipment.
03371 04/16
Important: Retain these instructions for future use.
Advertisement
Related Manuals for Gasmate CH205HTODS
Summary of Contents for Gasmate CH205HTODS
- Page 1 COLUMN HEATER Model No. CH205HTODS The ideal solution for extending the season of outdoor entertaining Creates a stylish and attractive ambience Rotary piezo ignition Includes a safety ‘tip-over’ switch that halts supply of gas to the unit should it be accidently knocked over...
-
Page 2: Important Safety Rules
INSTALLATION, OPERATION & MAINTENANcE INSTRUcTIONS Prior to assembling your appliance, the following must be reviewed. Compliance with the following should result in satisfactory heater operation. IMPORTANT SAFETY RULES This instruction manual should be retained for This appliance must only be used in a well future reference. - Page 3 INSTALLATION - OUTDOOR USE ONLY d. The flame pattern at the emitter grid Any modification to the heater not described in should be visually checked whenever the installation instructions may compromise the heater is operated. If flames extend safety of this appliance. Special concern is as beyond surface of the emitter grid or follows: black spot is accumulating on the emitter...
- Page 4 cOLUMN HEATER ASSEMBLY M8 screw 20mm long Gaurd cap M4 screws Tools Required 6mm long Phillips head screwdriver Gaurd 2 adjustable spanners Burner head (upper) M4 screw 6mm long STEP 1 Secure the base to the cylinder house body with five M6 x 15mm long screws, washers and nuts.
- Page 5 cOLUMN HEATER - FOR OUTDOOR USE ONLY Minimum clearance from combustible Surfaces*: *Combustible materials are considered to be wood, compressed paper, plant fibres, plastic or other materials that are capable of being ignited and burned. 500mm 540mm...
-
Page 6: Troubleshooting
TEST FIRING HEATER Test fire heater, following the lighting instructions. Leak test all gas connections with soapy water. Soap bubbles indicate gas leakage. DO NOT use a match to test for gas leaks. TROUBLE SHOOTING Problem Possible causes Air in gas line Low gas pressure Pilot won’t light Gas line turned ‘OFF’... -
Page 7: Safe Appliance Locations
SAFE APPLIANcE LOcATIONS This appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Any enclosure in which the appliance is used shall comply with one of the following: An enclosure with walls on all sides, but at least one permanent opening at ground level and no overhead cover (see Example 1). - Page 8 For any queries or assistance call customer Service (Australia Only) 1300 174 876 Hours of operation: Monday to Friday 8.30am - 5.30pm EST Do not return to place of purchase. Keep your purchase receipt, this will be required to make any claims under the 12 month warranty.