Advertisement
Quick Links
Model No. AH1069ODS, AH1060ODS, AH1063ODS
The ideal solution for extending the season of
outdoor entertaining
Creates a stylish and attractive ambience
Direct ignition
Includes a safety 'tip-over' switch that halts supply of
gas to the unit should it be accidentally knocked over
Oxygen depletion system for enhanced safety
Stainless steel burner for extra long-term reliability
Complete with hose and POL regulator
Efficient and powerful 36MJ/h output
Adjustable heat output
Operates for approximately 10 hours on a properly
filled 9Kg Propane cylinder
For outdoor use only
Gas certified to Australian standards
FOR YOUR SAFETY
If you smell gas:
1. Shut off the gas to the appliance.
2. Extinguish any open flame.
3. If odour continues, immediately call your gas supplier.
Do not store or use gasoline or other flammable vapour
and liquids in the vicinity of this or any other appliance.
WARNING
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
Read the instructions thoroughly before installing or
servicing this equipment.
FOR OUTDOOR USE ONLY
PROPANE GAS
Important: Retain these instructions for future use.
03671 04/18
Advertisement
Related Manuals for Gasmate AH1063ODS
Summary of Contents for Gasmate AH1063ODS
- Page 1 Model No. AH1069ODS, AH1060ODS, AH1063ODS The ideal solution for extending the season of outdoor entertaining Creates a stylish and attractive ambience Direct ignition Includes a safety ‘tip-over’ switch that halts supply of gas to the unit should it be accidentally knocked over...
-
Page 2: Installation
Installation, Operation and Maintenance Instructions INSTALLATION Proper clearance from combustible materials must Important Safety Rules be maintained at all times. The minimum clearances are as follows: This appliance must only be used in a well Minimum Clearance from Combustibles: ventilated area. Side Rear This appliance shall not be installed or used... - Page 3 The hose must be protected from contact with Any modification to the heater not described in the hot or sharp surfaces both during use and while installation instructions may compromise the safety of in storage. The hose assembly should be visually this appliance.
- Page 4 AREA HEATER ASSEMBLY WING NUT Tools Required Phillips head screwdriver, 2 Adjustable spanners MESH GUARD Note: Remove any transit protection material STEP 1 Attach the brackets onto the base with four M8 x 16mm bolts, then attach the cylinder cover with eight M5 x 10mm screws and nuts.
- Page 5 AREA HEATER - For Outdoor Use Only Minimum Clearance from Combustible Surfaces*: 500mm 450mm *Combustible materials are considered to be wood, compressed paper, plant fibres, plastic or other materials that are capable of being ignited and burned.
-
Page 6: Troubleshooting
TEST FIRING HEATER Test fire heater, following the lighting instructions. Leak test all gas connections with soapy water. Soap bubbles indicate gas leakage. DO NOT use a match to test for gas leaks. TROUBLE SHOOTING Problem Possible Causes Solution Main burner will No gas Replace cylinder not light... - Page 7 SAFE APPLIANCE LOCATIONS This appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Any enclosure in which the appliance is used shall comply with the following: An enclosure with walls on all sides, but at least one permanent opening at ground level and no overhead cover (see Example 1).
- Page 8 For any queries or assistance call Customer Service (Australia Only) 1300 174 876 Hours of operation: Monday to Friday 8am - 5pm EST Do not return to place of purchase. Keep your purchase receipt, this will be required to make any claims under the 12 month warranty.