Table of Contents
Advertisement
7. NEVER put two LATCH connectors on one
vehicle LATCH anchor .
8. Test infant restraint for secure installation as
described in infant restraint "Final Safety Check"
page 42.
9. Check that the LATCH stays tight and does not
slip from the tightened position.
10. To remove LATCH, push button while
pulling on the LATCH belt as shown .
11. Press and hold LATCH release hinge .
12. Push connector in, lift connector up and
pull out (away from anchor point) .
13. Repeat steps 11 and 12 for other connector.
31
Advertisement
Table of Contents
Need help?
Do you have a question about the MODES JOGGER and is the answer not in the manual?
Questions and answers