Page 2
E - Release Button A - Seat Pad the booster seat to chair using covers before using the product. F - Cinch Strap B - Rear Attachment the attachment straps or fold- • Do not leave the product near Straps (black) G - Fold-away Arm away arm.
Page 3
Attach to Chair: Fold-away Arm Attach to Chair: Fold-away Arm NOTE: Only one method of installation is required; choose either 2. Line up the Booster Seat with installation with Fold-away Arm or installation with Straps. the front of the Chair. Slide the Booster Seat towards the back of the Chair.
Page 4
Fold-away Arm is flat against the bottom of the chair (as shown). Locate the Cinch Strap on the back of the booster. Pull on the Cinch Strap to tighten the Fold-away Arm and lock down Booster Seat.
Page 5
NOTE: Only one method of installation is required; choose either squeeze the release button installation with Fold-away Arm or installation with Straps. to allow the Cinch Strap to slide through the handle and Attachment Strap Install: release tension on the Fold- away Arm.
Page 6
Attach to Chair: Attachment Straps Attach to Chair: Attachment Straps 7. Center the seat on the chair, 9. Make sure the Booster is making sure the back of the not overhanging the chair seat Booster is against the chair back. and the Booster is centered, then secure the Booster by fully tightening the Rear and Lower...
Page 7
Using the 3-point Harness Removing Seat Pad 10A. Unfasten the 3-point harness by pressing the center button on Crotch Strap Buckle. Pull out both Waist Clips from the Crotch Strap Buckle. 11A. Remove the Seat Pad from the base for cleaning. 10B.
Page 8
Removing Harness Straps Removing Harness Straps 13. To remove the Straps from the Harness Strap Plates. Push the Strap up to release the fold lock loops. Unfold the loops to lay flat and then pull the Strap from the Harness Strap Plate, as shown.
Page 9
Re-attaching Harness Straps Re-attaching Harness Straps 14. To re-attach the Harness Straps, lay out the Harness Plate and the Harness Straps as shown. With the loops flat, thread the Harness 15. Then fold the loops Straps through the bottom of together and pull down on the Harness Plates.
Page 10
Re-attaching Harness Straps Re-attaching Seat Pad 16A. Line up the Waist Belt 17A. To re-attach the Seat Pad, Harness Plate with the thread the Harness Straps Harness Slot (as shown) and through the correct openings slide it down until it clicks into and press the Seat Pad down place.
MAINTENANCE Periodically check the product for loose screws, or worn parts. Replace or repair the parts as needed. Use only Chicco replacement parts. Keep product in a dry place. Prolonged exposure to direct Fold-away Arm: sunlight may cause plastic parts to warp.
Page 12
For More Information For USA customers : If you have any questions or comments about this product, or are missing any of the parts, please do not return this product to the store. Contact us in one of the following ways: (877)-424-4226 info.usa@artsana.com www.chiccousa.com...
Need help?
Do you have a question about the CINCH and is the answer not in the manual?
Questions and answers