Viva Pet Fountains ™ Before we start: Care Instructions To keep fresh, clean water flowing for your pet, remember these three simple tasks: Refill often. Keep the water level up. If the water level gets low, the pump will shut off and an LED on the pump will glow red.
What you have: 140 oz model 64 oz model Tray Pump housing Carbon filter (contains activated carbon and ion-exchange resin) Silicone cap Pump Adaptor Foam filter Bowl 64 oz model 140 oz model...
Setup instructions Disassemble the pump for cleaning before use: Highest flow Lowest flow Flow-control knob Remove the faceplate by pulling Remove the stator by pulling Use a fingernail to pull out the forward on the small tab. forward on the lip behind the impeller, which is held in place flow‑control knob.
Page 5
Install the pump, foam filter and pump housing: Place the foam filter around the Place the pump housing with pump Insert the pump into the pump faceplate of the pump inside the and foam filter in the tabbed area housing. Push it all the way in. pump housing.
Page 6
Route the power cord and install the carbon filter: Feed the power cord down Insert the silicone cap and fold its Rinse the carbon filter with water. through the tube in the bowl and top edge down over the top of the Holding the carbon filter with the out through one of the notches in tube.
Use instructions Place the fountain where your pet will use it. Fill the bowl with water up to the max fill line on the window and then fit the tray onto the top of the bowl. The bubbler at the center of the tray should connect with the tube on the pump housing.
Need help?
Do you have a question about the Viva and is the answer not in the manual?
Questions and answers