Page 5
Explanation ofwarning diagrams Indicating a Ind cating the Indicating a high Indicating that the material used is prohibited act that matters needing voltage danger zone, lammable. beware may cause fatal or attention that may beware of high ofire. cause personal voltage.
Page 6
Never insertmetal materials such as iron needles or wires into vents or vents used for air circulation in the machine. This may ause eIectric shock or personal injurydue to the accidental operation ofthe moving parts. Be sure to place the SIush Machine frmly on solid ground. Ifthe ground is not strong enough or is not frmly placed, it will cause damage due to the overturning or capsizing ofthe slush Machine.
Page 7
There is no obstruction around the appliance or in the embedded structure to keep the ventilation open. Before cleaning, maintaining or inspecting the sIush Machine, unpIug the power SUPPIY to prevent electric shock or personal injury. agents, y u should If some mode suse combustible refrigerants and l mmable foamin beware offre (there is a "...
Page 8
1 . solid and flat ground. To operate the SIush Machine correctIY and getthe best performance, please putthe SIush Machine where the following conditions are met. 2. stay away from the place where the heat source is generated. Avoid putting slush Machines near heating equipment, such as gas lames or stoves. The heating ofthe SIush Machine will lead to a decrease in cooling ei iency.
Page 9
2 . The elevation is no more than 2000 meters. 3. The ambient temperature is in the range of10 ℃ - 32 ℃ · 4. when the temperature is not higher than 31 ℃ , the maximum re ative humidity is 80 % , and the maximum reIative humidity decreases linearIy with the increase oftemperature.
Page 12
Single bowl parameter table display code parameter name Defaults Setting range slushinbowltemperaturesetpoint 0℃-9.5℃ -1.5℃ colddrinkinbowltemperaturesetpoint 5℃ 0℃-10℃ Double bowl parameter table display code parametername Defaults Setting range slushinbowl 1 temperatureset point -1.5℃ 0℃-9.5℃ slushinbowl2 temperatureset point -1.5℃ 0℃-9.5℃ 5℃ 0℃-10℃ slushinbowl2 temperatureset point colddrinkinbowl3 temperaturesetpoint 0℃-10℃...
Page 14
Freezing cylinder adjustment lever Note: The adjusting rod of the freezing cylinder has been adjusted before leaving the factory, please do not adjust the adjusting rod of the freezing cylinder at will. Freezing cylinder adjustment lever...
Page 20
PowerSupply Power switch Protector Compressor Compressor Relay Runing capacitor Starting capacitor Lamp Control panel...
Page 22
Environmental protection List 1 . The name and content of non-environmentally friend y substances or elements in the product. on-environmenta ly friendIY Substances or elements cr V compressor Motor : Indicatin thatthe content ofthe harmful substance in all ho ogeneous aterials ofthe component is below the limit speci ed in GB T2 572 .
Page 24
product specifications RLC12× Model No AC120V 60Hz Rated voltage 500W Input power Rated current volume 12L×1 Refrigerating R290/659 shock protection Type Foam Materia Cyc opentane Dimensions 525×200×825 mm N/SN climate Type Net weight 2 6 KG Model No RLC12×2 AC120V 60Hz Rated voltage 900W Input power...
Page 25
Model No RLC12×3 AC120V 60Hz Rated voltage 1200W Input power Rated current volume 12L×3 Refrigerating R290/165g shock protection Type Foam Materia Cyc opentane Dimensions 525×604×825 mm N/SN climate Type Net weight 59 KG Troubleshooting instructions solutions FauIts cause Analysis Insert the power plug into a No power input The machine cannot suitable outlet...
Page 26
The master switch is not turned on Turn on the master switch The sherbet ofthe serrano is not Adjust the hardness ofsherbet adjusted to the right level clean the condenser The condenser is too d irty The machine does not The SIush Machine is close to the make sherbet heat source , and the heat...
Need help?
Do you have a question about the RLC12X1 and is the answer not in the manual?
Questions and answers