Connecting The Power Cord - Onkyo M-5000R Instruction Manual

Connecting the Power Cord

1 Make sure that the main power of the power
amplifier is turned off.
2
Connect all of your components.
3
Connect the supplied power cord to the amplifier's
AC INLET.
4 Plug the power cord into an AC wall outlet.
En
16
AC INLET
Supplied power cord
Tip
• To reduce noise, do not tie the signal cable and power cable
together. Wire them so that they are away from each other.
To an AC wall outlet
(Plug type varies from
country to country.)
Note
• Never disconnect the power cord from the power amplifier
while the other end is still plugged into a wall outlet. Doing so
may cause an electric shock. Always disconnect the power cord
from the wall outlet first, and then the power amplifier.
• Turning on the power amplifier may cause a momentary power
surge that might interfere with other electrical equipment on the
same circuit. If this is a problem, plug the power amplifier into a
different branch circuit.
• Do not use a power cord other than the one supplied with the
power amplifier. The supplied power cord is designed
exclusively for use with the power amplifier and should not be
used with any other equipment.