Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Onkyo M-5000R
Summary of Contents for Onkyo M-5000R
- Page 1 Power Amplifier M-5000R Instruction Manual...
-
Page 2: Important Safety Instructions
Leave 30 cm (12") of free space at the top and sides manufacturer. into the apparatus, and 10 cm (4") at the rear. The rear edge of the shelf or C. If the apparatus has been exposed to rain or water, board above the apparatus shall be set 10 cm (4") D. -
Page 3: Precautions
This is normal. water. Dry the unit immediately afterwards with a • If you do not use this unit for a long time, it may not clean cloth. Don’t use abrasive cloths, thinners, work properly the next time you turn it on, so be Modèle pour les Canadien... - Page 4 Check for the ASTA mark or the BSI mark on the body of the fuse. If the power cord’s plug is not suitable for your socket outlets, cut it off and fit a suitable plug. Fit a suitable fuse in the plug.
-
Page 5: Amplifier Precautions
Important Safety Instructions and this page of Amplifier Precautions. Make sure that the floor or cabinet or rack where it will be Connected speakers should have an impedance of 4 ohms located is strong enough to support its weight. -
Page 6: Care
M-5000R. • Never perform a “thumb test” (checking whether current is reaching the lead wire on the hot end of the input by touching it with your fingers) on the ends of the input jacks or input cables. -
Page 7: Features
Features • 150 W/Ch (4 ohm, 20 Hz - 20 kHz, 0.05%, 2 Channels Driven, IEC) • A WRAT (Advanced Wide Range Amplifier Technology) • DIDRC (Dynamic Intermodulation Distortion Reduction Circuitry) • Quad Push-Pull Amplification Design with Three-Stage Inverted Darlington Circuitry •... -
Page 8: Technology
Generally, S/N measures the ratio when sound out to 100 kHz. this circuitry requires very advanced control is and not produced, but takes no account of the technology in order to be incorporated into the noise generated during sound reproduction. -
Page 9: Block Diagram
Block Diagram DIDRC (Dynamic Intermodulation Distortion Reduction Circuitry) -
Page 10: Supplied Accessories
Mono mini-plug cable (1.8 m/5.9 ft) ........ -
Page 11: Table Of Contents
Other ........................6 Lightning storms ....................6 Power........................6 Features ........................7 Technology .......................8 Block Diagram ......................9 Supplied Accessories ....................10 Getting to Know the Power Amplifier..............12 Front Panel ......................12 Rear Panel ......................13 Installing the Power Amplifier................14 Connections Connections ......................15 Cable and Jacks ....................15 Connecting the Power Cord................16 Connecting a Preamplifier .................17... -
Page 12: Getting To Know The Power Amplifier
Getting to Know the Power Amplifier Front Panel The page numbers in parentheses show where you can find the main explanation for each item. a Power meter d POWER switch (➔ (➔ This is the main power switch. When set to OFF, the The power meter shows the output power level. -
Page 13: Rear Panel
Connects to the 12V trigger input and output jacks on suitable wall outlet. the other component to control the power amplifier. Do not connect XLR and RCA at the same time. It This enables the amplifier to turn on or go into may damage the power amplifier. -
Page 14: Installing The Power Amplifier
10 cm (4") Install the power amplifier on a sturdy rack or shelf. Position it so that its weight is evenly dispersed on its four legs. Do not install the power amplifier in a place with vibration or an unstable location. -
Page 15: Connections
The tip polarity of the connectors are as shown in the right. polarity Note • Push plugs in all the way to make good connections (loose connections can cause noise or malfunctions). Right! • To prevent interference, keep audio cables away from power cords and speaker cables. -
Page 16: Connecting The Power Cord
Plug the power cord into an AC wall outlet. different branch circuit. • Do not use a power cord other than the one supplied with the power amplifier. The supplied power cord is designed exclusively for use with the power amplifier and should not be... -
Page 17: Connecting A Preamplifier
Connecting a Preamplifier Stereo Connection Preamplifier P-3000R Power Amplifier M-5000R Right speaker Left speaker This is an example of the stereo connection using the preamplifier P-3000R. Note • Set the INPUT SELECT switch to RCA side. - Page 18 Important: • When making the bi-amping connections, be sure to remove the jumper bars that link the speakers’ tweeter (high) and woofer (low) jacks. • Bi-amping can be used only with speakers that support bi-amping. Refer to your speaker manual.
- Page 19 • The power amplifier uses the European type XLR jack (pin 2 hot). If the AV controller/preamplifier with the USA type jack (pin 3 hot) is connected, the phase will be reversed.
-
Page 20: Basic Operations
Standby LED goes off. POWER to the OFF position (@). Note • After a certain period of warming up, the temperature of the • See “Setting Auto Standby (ASb)” for the auto standby function power amplifier’s components and internal temperature are (➔... -
Page 21: Switching The Power Meter Range
METER RANGE in the following order: Set ON/OFF by switching the AUTO STANDBY ×1 (default), ×10, Off switch. The x 1, x 10 LEDs and the Off LED will light according to the set status of METER RANGE. ASb enabled. OFF: ASb disabled. -
Page 22: Troubleshooting
SELECT switch is switched to the RCA side. • Check the connection in case of bi-amping connection. Audio performance • Audio performance will be at its best about 10 to 30 minutes after the power amplifier has been turned on and had time to warm up. -
Page 23: Specifications
European: × Analog Stereo Inputs RCA IN-L, RCA IN-R (Stereo) 2 ch 80 W at 8 ohms, 20 Hz - 20 kHz, 0.05 %, Balance Inputs XLR IN 2 ch driven (IEC) × 2 ch 150 W at 4 ohms, 20 Hz - 20 kHz, 0.05 %, ■... - Page 24 The Coach House 81A High Street, Marlow, Buckinghamshire, SL7 1AB, UK Tel: +44-(0)1628-473-350 Fax: +44-(0)1628-401-700 Unit 1 & 12, 9/F, Ever Gain Plaza Tower 1, 88, Container Port Road, Kwai Chung, N.T., Hong Kong. Tel: 852-2429-3118 Fax: 852-2428-9039 http://www.ch.onkyo.com/ 1301, 555 Tower, No.555 West NanJin Road, Jin an, Shanghai,...
Need help?
Do you have a question about the M-5000R and is the answer not in the manual?
Questions and answers