Page 1
Connections........7 Advanced Operations ....9 Instruction Manual Others...........10 Thank you for purchasing an Onkyo Power Amplifier. Please read this manual thoroughly before making connections and plugging in the unit. Following the instructions in this manual will enable you to obtain optimum performance and listening enjoyment from your new Power Amplifier.
WARNING: AVIS WARNING RISK OF ELECTRIC SHOCK RISQUE DE CHOC ELECTRIQUE TO REDUCE THE RISK OF FIRE OR ELECTRIC DO NOT OPEN NE PAS OUVRIR SHOCK, DO NOT EXPOSE THIS APPARATUS TO The lightning flash with arrowhead symbol, within an RAIN OR MOISTURE.
003 DU CANADA. wet or damp. If water or any other liquid gets inside Sur les modèles dont la fiche est polarisée: this unit, have it checked by your Onkyo dealer. ATTENTION: POUR ÉVITER LES CHOCS 8. Handling Notes ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS...
Front Panel For detailed information, see the pages in parentheses. ON/STANDBY button Power indicator This button is used to turn the main power on/off. The power indicator will be lit blue when the main power of M-5010 is turned on.
These are the analog audio inputs and outputs. Use an M-5010. RCA-type audio connection cable to connect the To turn on the M-5010 with the signal input from the output jacks of the device to the INPUT jacks on the 12V TRIGGER IN jack, set the TRIGGER switch to M-5010.
Wrong! Connecting the AV Receiver When connecting the M-5010 to AV Receiver, connect the INPUT jacks of the M-5010 to the PRE OUT jacks of the AV Receiver, and connect the front speakers to the SPEAKERS terminals of the M-5010.
Connecting Your Speakers Note Right Left • Pay close attention to speaker wiring polarity. In other words, connect positive (+) terminals only to positive (+) terminals, and negative (–) terminals only to negative (–) terminals. If you get Speakers them the wrong way around, the sound will be out of phase and will feel unnatural.
Switch the TRIGGER selector on the unit’s rear panel. Switch the AUTO STANDBY selector on the unit’s [12V TRIGGER] rear panel. The M-5010 will be turned on when the 12V TRIGGER jacks are provided with power. [ON] Enables auto standby.
The Power indicator lights blue, but no preamplifier to the minimum so that when the sound comes from the speaker or the M-5010 is turned on, you do not hear loud unwanted volume is very low. sounds. • Bad connections or wiring.
Specifications Rated Output Power (FTC) 75 watts minimum continuous power per channel, 8 ohm loads, 2 channels driven at 1 kHz, with a maximum total harmonic distortion of 0.08 % (FTC) 65 watts minimum continuous power per channel, 4 ohm loads, 2 channels driven at 1 kHz, with a maximum total harmonic distortion of 0.08 % THD+N (Total Harmonic Distortion+N) 0.08 % (Rated Output Power)
Page 12
Unit 1033, 10/F, Star House, No 3, Salisbury Road, Tsim Sha Tsui Kowloon, Hong Kong. Tel: 852-2429-3118 Fax: 852-2428-9039 http://www.onkyochina.com/ 1301, 555 Tower, No.555 West NanJin Road, Jin an, Shanghai, China 200041, Tel: 86-21-52131366 Fax: 86-21-52130396 http://www.cn.onkyo.com/ C1210-1 SN 29401276 (C) Copyright 2012 Onkyo Corporation Japan. All rights reserved.