Dormakaba LA GARD 700 BASIC Instructions

FEATURES
LOW BATTERY WARNING
+ Low Battery Warning - Keypad will repeat signal 5 times
during lock opening. This warning indicates that the battery is
low and should be replaced.
+ Critical Low Battery Warning - Keypad respond to any key
press by repeating this signal 10 times. This warning indicates
that the lock cannot be safely operated. The batteries must be
replaced before the lock will operate.
OPENING THE LOCK
1. Enter valid six (6) digit combination (the default code is 123456). The lock will signal a valid combination entry with a double beep.
2. Within four (4) seconds, turn the keypad to the open position (clockwise).
3. Pull door open.
4. Close the door, and check the locked status of the container with the handle.
+ Invalid Combination Entry - Lock will signal three (3) times.
+ Security Considerations - On safes using more than one lock the swing bolt must lock first.
1. Enter "zero" six times.
2. Enter your existing six (6) digit combination one time.
3. Enter your NEW six (6) digit combination two times.
4. If a mistake is made wait thirty (30) seconds and repeat steps
1 - 3.
5. Test lock operation several times before closing the door.
V1.1_2210 | Division of Davcor Group Pty Ltd
700BASICSQB
HTTPS://DAV.GROUP/QTOSC
HTTPS://DAV.GROUP/QMBFY
INSTRUCTIONS
CHANGING USER COMBINATION
ALWAYS PERFORM THIS OPERATION WITH THE DOOR OPEN
| www.smartlock.com.au
There is a QR sticker on the face of your safe that looks like this. If
you scan this QR code it will take you to the latest instructions and
a series of how to videos that details the instructions below.
If there is no QR code on the safe go to
WRONG TRY PENALTY
+
Four (4) consecutive invalid combination initiates five (5)
minute delay period the keypad will not respond to any
button presses and the keypad will flash once every 10
seconds while the lock is counting penalty time.
USER COMBINATION
+
Open Lock
+ Change Combination
AUDIO AND VISUAL SIGNAL
+ Double signal - two (2) LED flashes and two (2) beeps - indicates
entry is valid or accepted.
+
Triple signal - three (3) LED flashes and three (3) beeps -
indicates invalid or not accepted.
CAUTION: When selecting a combination do not use birthday or
other predictable data that could give correlation between the user
and combination.Keep the combination secret.
+ Valid Combination Entry - Double signal after valid six (6) digit
combination is entered.
+ Invalid Combination Entry - Triple signal indicates the old
combination is still valid.
Page 1
| www.smartlock.co.nz |
700 BASIC
Instructions
Dead Bolt
https://dav.group/qmbfy
ABN. 95 003 562 598