Denon AVR-2803S Operating Instructions Manual page 25

Enter the setting.
The System Setup Menu reappears.
[1] Setting the power amplifier assignment
Make this setting to switch the power amplifier for the surround back channel to ZONE2.
If ZONE2 is selected, the signal that selected at ZONE2 is output at "SURR. BACK/ZONE2 PREOUT" terminals.
1
At the System Setup Menu select "Zone2 Control"
and press the ENTER button.
System Setup Menu
Speaker Configuration
Delay Time
Channel Level
Digital In Assignment
Video In Assignment
Dolby Digital Setup
_Zone2 Control
2
The "Zone2 Control" screen appears.
Select "Power Amp Assignment" and press the
ENTER button.
Zone2 Control
_Power Amp Assignment
Zone2 Vol, Level
Exit
Select "Surround Beck" to use as the surround back
channel, "Zone2" to use as Zone 2 out.
Power Amp Assignment
<13fi_f_ : Zone2
Power Amp Assignment
4Surr0undBack : k'Jli_'J_l_
When "Surround Back" is selected When "Zone2" is selected
(_ Enter the setting.
At the "Zone2 Control" screen, select "Exit" and press the ENTER button.
The System Setup Menu reappears.
[2] Setting the Zone2 vol. level
Set the Zone 2 pre-out output level adjustment.
At the System Setup Menu select "Zone2 Control"
Menu
System Setup
and press the ENTER button.
Speaker Configuration
Delay Time
Channel Level
Digital In Assignment
Video In Assignment
Dolby Digital Setup
_Zone2 Control
25