Welcome to Studio 89 Register your Studio 89 speakers to ensure the best possible product and customer support Thank you for purchasing our Studio 89 speakers, you’re now ready to start your journey to breathtaking sound. Register your speakers using the QR code Born in the 1980s, the legendary Studio Series brought studio monitor- or visit monitoraudio.com/registration...
Unboxing Before you unpack your speakers, please make sure that there is plenty of clean floor area available. Pictorial guides printed on the carton show you the ideal method for unpacking. Lay the box down on the floor so the top of the carton is facing up. Remove the Accessories and Documents envelope.
Setting up 2-Channel Positioning When arranging a 2-channel system, the listening position and the loudspeakers should form an equilateral triangle. The speakers should be positioned approximately 6 - 10 feet (1.8 - 3m) apart. The ideal distance from the rear wall varies depending on tastes and room acoustics, however, the speakers need to be a minimum of 3 feet (91cm) from the side walls.
Wiring your speakers Bare Wire Connection Unscrew the binding posts and pass the bare wire through the hole in the binding post. Tighten the binding post to clamp the wire in place. Bare Wire Connection Banana Plugs Banana Plugs Remove the small red and black terminal caps. Insert the banana plugs into the standard 4mm holes in the centre of the terminal.
This can be done naturally over time: like a fine wine the performance will improve with age. Never use solvents or aggressive cleaning agents on your Studio 89 loudspeakers. When in doubt, test the cleaning product on an inconspicuous area on the cabinet and let it sit for several Alternatively if you wish to run the speakers continuously on loop you can decrease the audible days before committing to its use on visible portions of the cabinet.
Dedicated stands are available, to perfectly compliment both aesthetically In the unlikely event that there is a defect with this product, it is covered by and acoustically with the Studio 89 loudspeakers. They feature sturdy ‘no the Monitor Audio manufacturer’s warranty, provided that the product was ring’...
Specifications Model Studio 89 System Format 2-Way Sensitivity (2.83v @ 1m, Free-Field) 86dB Recommended Amplifier Power 50 – 300 W (RMS into 4 Ohm, Music Signal) Continuous Power Handling (RMS 150 W into 6 Ohms, Pink Noise with 6dB Crest Factor)
Need help?
Do you have a question about the STUDIO 89 and is the answer not in the manual?
Questions and answers