To Operate Fan Only - Frigidaire FAK104R1V - 10,000 BTU Slider Use And Care Manual

Air Conditioner Features
(continued)

TO OPERATE FAN ONLY:

TO USE THE ENERGY SAVER FEATURE:
SLEEP FEATURE:
DO THIS:
PRESS
MODE BUTTON
CHOOSE
FAN ONLY
DO THIS:
PRESS
MODE BUTTON
CHOOSE
ENERGY SAVER
DO THIS:
PRESS
SLEEP BUTTON
YOU WILL SEE:
Note: Use this function only when cooling is not desired, such as
for room air circulation or to exhaust stale air (Remember to open
the vent during this function, but keep it closed during cooling for
maximum cooling efficiency). You can choose any fan speed you
prefer.
During this function, the display will show the actual room
temperature, not the set temperature as in the cooling mode.
YOU WILL SEE:
Note: In this mode, the fan will continue to run for 3 minutes after
the compressor shuts off. The fan then cycles on for 2 minutes at
10 minute intervals until the room temperature is above the set
temperature, at which time the unit turns back on.
YOU WILL SEE:
Note: In this "MODE" the selected temperature will increase by 2
degrees F 30 minutes after the mode is selected. The temperature
will then increase by another 2 degrees F after an additional 30
minutes. This new temperature will be maintained for 7 hours
before it returns to the originally selected temperature. This ends
the "Sleep" MODE and the unit will continue to operate as originally
programmed. The "Sleep" MODE program can be cancelled at
any time during operation by pressing "Sleep" MODE button.
7
LIGHT On
LIGHT On
LIGHT On