Advertisement
Quick Links
Model
GX Series
Updated 06/22
Triplex Plunger Pump
Operating Instructions/
Repair Instructions Manual
Consumer Pump
Horizontal/Vertical Pump
with built-in Thermal
Relief Valve and Siphon
Injector
Contents:
Installation Instructions: page 2
Pump Specifications:
Exploded View/Kits:
Torque Specifications:
Repair Instructions:
Dimensions:
Warranty Information:
page 3
page 4
page 5
pages 6-7
back page
back page
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Giant GX Series
Summary of Contents for Giant GX Series
- Page 1 Model Triplex Plunger Pump Operating Instructions/ Repair Instructions Manual GX Series Consumer Pump Horizontal/Vertical Pump with built-in Thermal Relief Valve and Siphon Injector Contents: Installation Instructions: page 2 Pump Specifications: page 3 Exploded View/Kits: page 4 Torque Specifications: page 5...
-
Page 2: Installation Instructions
4. Run the pump dry approximately 10 seconds to drain the water before exposure to cap (on the top of the pump). freezing temperatures. NOTE: Contact Giant Industries for Service School Information. Phone: (419)-531-4600... - Page 3 Specifications Model GX Series U.S. (Metric) Flow ................2.5 GPM ....(9.5 LPM) Maximum Discharge Pressure ........2500 PSI ..... (172 bar) Maximum Inlet Pressure ...........Up to 90 PSIG ..6.2 Bar Pump Speed ..................3450 RPM Plunger Diameter ............0.63” ....16 mm Stroke ....................
- Page 4 GX SERIES PARTS LIST ITEM# Part# Description QTY. 06256 Push in Seat 07805 Radial Shaft Seal ITEM# Part# Description QTY. 06310A Adapting Flange 06227 8mm Ball 06294 O-Ring (86 x 2.5mm) 07917A Washer 07918 Adjusting Spring 06300A Rear Bearing 07919...
- Page 5 GX Series EXPLODED VIEW Plunger Packing Kit Oil Seal Kit # 09465 # 09468 Item Part # Description Qty. Item Part # Description Qty. 06290 Support Ring 06316 Plunger Oil Seal 06315 V-Sleeve Valve Assembly Kit Unloader Repair Kit # 09466...
- Page 6 REPAIR INSTRUCTIONS - GX SERIES 1. With a 14mm socket 2. Remove the valve spring 3. With a crescent wrench, wrench, remove the three (18) and valve cone (36) remove the kickback valve discharge valve plugs from the manifold (35).
- Page 7 GX2525 EXPLODED VIEW 10. Tap the back of the mani- fold (35) with a rubber mallet to dislodge, and slide off the plungers. (8). Take note of the position of the discharge port so as to place the manifold in the same position during reas- sembly.
- Page 8 Liability under this warranty is on all non-wear parts and limited to the replacement or repair of those products returned freight prepaid to Giant Industries which are deemed to be defective due to workmanship or failure of material. A Returned Goods Authorization (R.G.A.) number and completed warranty evaluation form is required prior to the return to Giant Industries of all products under warranty consideration.
Need help?
Do you have a question about the GX Series and is the answer not in the manual?
Questions and answers