Komfovent KLASIK User Manual page 27

• Efficiency
Heat exchanger parameters are displayed in real-time.
In this menu you can also calibrate CF heat exchanger
bration was successful and the display shows "Calibrated", there is no need to repeat it. During calibration,
the unit will run for 10 minutes by changing fan speed and will be measuring pressure inside the unit, there-
fore, do not open the unit door, do not adjust the duct system or change parameters at that time. To stop
calibration, turn off the unit with a control panel.
Efficiency status
Heat exchanger efficiency
83%
Energy saving
90%
Energy recovery
4,1 kW
CF exchanger calibration
Calibrated
• Filter status
In this menu you can check filter impurity levels. When the contamination level reaches 100%, a mes-
sage urging to change filters is displayed. After changing the filters, delete the message to reset the con-
tamination level. If you have changed the filters in advance, without receiving a message, you can also reset
their impurity level in the same window.
Filter status
Outdoor air filter impurity
67%
Extract air filter impurity
53%
Clean filters calibration
Only in CF units.
1
UAB KOMFOVENT we reserve the right to make changes without prior notice
KLASIK_user manual_24-03
Filter status
Outdoor air filter impurity
67%
Extract air filter impurity
Reset?
53%
Clean filters calibration
, if not calibrated during the first start-up. If cali-
1
27