Table of Contents
Advertisement
RX CONTROLLER
FIRMWARE UPDATE
A fi rmware update can be carried out directly with the ROBO Pro Coding app. An internet con-
nection must be available on the device on which ROBO Pro Coding is running.
If a fi rmware update is required, a message is displayed in ROBO Pro Coding as soon as the con-
troller is connected. The power supply must not be interrupted during the update.
Start update via „Update now" button. The fi rmware is transferred to the RX Controller.
Start update via „Update now" button. The fi rmware is transferred to the RX Controller.
After transfer and installation, the RX Controller must be switched on again.
The update process via USB takes about 3 minutes and via Bluetooth about 15 minutes.
During the fi rmware update, the LED lights up as follows:
LED yellow, slow blinking
LED yellow, fast blinking
LED off
Press the ON/OFF button and the red
Bluetooth button simultaneously, then
connect the power supply
Firmware is being transferred
Firmware is being updated
Update has been completed, controller
needs to be powered on again
Firmware is being repaired
10
Advertisement
Table of Contents
Need help?
Do you have a question about the RX CONTROLLER and is the answer not in the manual?
Questions and answers