Advertisement
Z8 Encore! XP
Quick Start Guide
Page 8
11. The three LEDs on the development board begin blinking in sequence. If the LEDs do
not blink, start over from Step 3 on page 5.
Note:
(Z8F04A08100KIT development kits only) LED D2/PA0 is shared with the
DBG pin when the board is in debug mode. The LED will therefore not be
fully illuminated.
12. Press the
site direction.
For more information about using ZDS II and building projects for your Z8 Encore!
development kit, refer to the ZiLOG Developer Studio II–Z8 Encore!
(UM0130).
Getting Started Using ZDS II
Downloaded from
Elcodis.com
electronic components distributor
®
Development Kits
pushbutton to change the sequence of the LEDs to blink in the oppo-
TEST
®
®
User Manual
QS004303-0205
Advertisement
Need help?
Do you have a question about the Z8 Encore! XP Series and is the answer not in the manual?
Questions and answers