Related Manuals for Phytec phyCORE-i.MX 8M Plus
Summary of Contents for Phytec phyCORE-i.MX 8M Plus
- Page 1 XK048/XK049 (Heatsink/Heatspreader) Assembly Instructions for phyCORE-i.MX 8M Plus (LAN-110e.A0) A Product of PHYTEC Technology Holding Company...
- Page 2 XK048/XK049 (Heatsink/Heatspreader) Assembly Instructions for phyCORE-i.MX 8M Plus (LAN-110e.A0)
- Page 3 The task of the heatspreader is to distribute/convey the heat loss generated by the components on the PCB side of the phyCORE-i.MX 8M Plus. In detail, these are the CPU, the PMIC voltage regulator, the RAM bank, and the Ethernet PHY transceiver.
-
Page 4: Mounting Steps
XK048/XK049 (Heatsink/Heatspreader) Assembly Instructions for phyCORE-i.MX 8M Plus (LAN-110e.A0) Mounting Steps Attach the supplied threaded standoffs (Pos. 5) to your carrier board by placing them on top of the hole and screwing them from below with the Pan Head Screw (Pos. 3) and the washers (Pos. 6). Recommended torque = 0.2Nm - 0.3Nm. - Page 5 XK048/XK049 (Heatsink/Heatspreader) Assembly Instructions for phyCORE-i.MX 8M Plus (LAN-110e.A0) 2. Insert the phyCORE module into the socket and check that the internal threads of the standoffs are visible through the holes in the phyCORE. 2 phyCORE Module Installation...
- Page 6 XK048/XK049 (Heatsink/Heatspreader) Assembly Instructions for phyCORE-i.MX 8M Plus (LAN-110e.A0) 3. Remove the contact side protective film from the Thermal Pad and attach the Thermal Pad (Pos. 2) concurrent to the conductive shape on the Heatspreader. 3 Thermal Pad Setup...
- Page 7 XK048/XK049 (Heatsink/Heatspreader) Assembly Instructions for phyCORE-i.MX 8M Plus (LAN-110e.A0) 4. Attach the Heatspreader to the top of the phyCORE module while adjusting the position by looking through the mounting holes. 4 Heatspreader Installation...
- Page 8 XK048/XK049 (Heatsink/Heatspreader) Assembly Instructions for phyCORE-i.MX 8M Plus (LAN-110e.A0) 5. Insert the Countersunk Screw (pos. 4) into the mounting holes and fix it. Recommended torque = 0.2 Nm - 0.3 Nm. The compression of the Thermal Pad will be approximately 33% (1mm/1.5mm).
-
Page 9: Revision History
XK048/XK049 (Heatsink/Heatspreader) Assembly Instructions for phyCORE-i.MX 8M Plus (LAN-110e.A0) Revision History Date Version # Changes to this Manual 01.08.2022 LAN-110e.A0 Preliminary Manual...
Need help?
Do you have a question about the phyCORE-i.MX 8M Plus and is the answer not in the manual?
Questions and answers