Oracode 660K/660I Easy Step Instruction
INSTALLING CYLINDRICAL MODELS 2
CAUTION: Perform the following steps with the door open.
!
1- Install the Strike and the Strike Box
Note: The handle height is aligned with the center of the strike.
For cylindrical latch models, ensure the dead-locking pin will stop
!
against the strike when the door is closed (see figure). An incorrect
installation that permits the pin to slip inside the strike may result
in a total lockout and will void the warranty of the complete lock
mechanism.
Use only the strike and strike box supplied. The use of non-approved
parts will result in a functionality problem and may void the
warranty.
Correct
4
Incorrect
6
2- Prepare the Door
If the door is already pierced for the cylindrical unit, you can use the cylindrical
unit and plate assembly to mark the position of the 3 mounting screw holes and
thumbturn hole (if applicable). Take care to position the plate parallel to the side
of the door. Otherwise refer to proper drilling template. Drill 1/2" diameter holes
from both side.
3- Install the Latch
4- Install the Cylindrical Unit
Insert the cylindrical unit from the outside of the door toward the inside, so that it
engages the latch as shown.
dormakaba Canada Inc.
/
" & 2
3
8
(S) Inside Trim
The cylindrical unit and plate assembly is shipped assembled in
factory for 1
If door thickness is different, refer to website:
https://www.dormakaba.com/us-en
5- Inside Trim Assembly for Cylindrical
For all models
On the inside trim assembly turn the lever to the correct horizontal rest position for
the handing of the door. Install the tension spring (L) between the handle plate (H)
Strike Kit
and the post (P).
For models with thumbturn
T
he inside Trim assembly for cylindrical includes parTs assembled aT The
facTory To conTrol The moTion of The ThumbTurn
spring
Install the additional tension spring (N) between the post (P) and the plate (Q), on
the side opposite the lever handle spring.
Dead Locking Pin
Closing
Direction
/
" BACKSET
3
4
(outside)
Parallel
" door thickness
3
/
4
.
Q
N
P
cyli
n
drical
unit
latch
E
,
and an addiTional
Need help?
Do you have a question about the 660K and is the answer not in the manual?
Questions and answers
How do I set it so it remains unlocked