Page 2
WARNING! Do not use an extension cord. Extension cords could present a safety hazard if not properly sized, become damaged or the connection falls into the sump pit. Do not attempt to disassemble the PumpSpy controller. There are no field serviceable parts or repair options! RISK OF EXPLOSION.
Page 3
Storage Temperature 0° to 70°C Operating Temperature 0° to 50°C The PumpSpy System requires a 12V Deep Cycle Battery (not included), 40 amp/hr minimum, 75 amp/hr or higher recommended. SLA/AGM Battery strongly recommended. UNPACKING Inspect this unit before beginning installation. Occasionally, products are damaged during shipment.
Cycle the Primary Sump Pump. The alarm will stop and the MAIN PUMP status LED will turn GREEN. WIFI CONNECTION Download the PumpSpy app from the App Store or Google Play. Follow the on-screen instructions to connect to a WiFi network.
STATUS INDICATOR REFERENCE CHART Use the chart below to identify the message associated with the color of each LED light on the PumpSpy Controller. = Yellow = Blinking Red = Red = Red/Green Alternating WATER LEVEL No Cycle Recorded High Water Alert...
UPS - LED and Audible Alarm STATUS AUDIBLE ALARM Top Green LED Twenty second blinking AC Power Operation Bottom Yellow LED Solid Bottom Yellow LED Battery (DC) Power Operation Middle Red LED Sounding once every six seconds Battery (DC) Power Exhausted Middle Red LED Continuous sounding UPS - Troubleshooting...
(the “Warranty Period”). During the warranty period, PumpSpy™ will repair or replace at no cost to you, to correct such defects in products found upon examination by PumpSpy™ to be defective in materials or workmanship.
Need help?
Do you have a question about the PS2000UG and is the answer not in the manual?
Questions and answers