PumpSpy BU-1500 Installation And Service Manual

PumpSpy BU-1500 Installation And Service Manual

Primary sump pump battery backup power system

Advertisement

INSTALLATION AND SERVICE MANUAL
PRIMARY SUMP PUMP BATTERY BACKUP POWER SYSTEM
BU-1500
NOTICE: INSTALLER - Please provide this manual to the property owner
responsible for the service and maintenance of the sump pump system.
2723 Kersten Court
Kalamazoo, Michigan 49048
www.PumpSpy.com
© 2021 PumpSpy. All Rights Reserved.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BU-1500 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for PumpSpy BU-1500

  • Page 1 PRIMARY SUMP PUMP BATTERY BACKUP POWER SYSTEM BU-1500 NOTICE: INSTALLER - Please provide this manual to the property owner responsible for the service and maintenance of the sump pump system. 2723 Kersten Court Kalamazoo, Michigan 49048 www.PumpSpy.com © 2021 PumpSpy. All Rights Reserved.
  • Page 2 GENERAL INFORMATION To ensure safe and reliable operation, please carefully read this service and installation manual in its entirety before installing and / or using this product. Reasonable care and safe methods in according with sound plumbing practices should be strictly adhered to. Before installation, refer to and understand all relevant local plumbing and electrical codes.
  • Page 3 OPERATION When 120VAC household power is available to the Power Unit and the unit is powered ON (Power Indicator is “GREEN”) , household power is directly routed through to both of the Output Power Outlets on this unit. While the CHARGER SWITCH is in the on position, the Power Unit is also charging the deep cycle battery. The Charging Indicator will be “RED”...
  • Page 4 INSTALLATION 1. Mount the power unit on the wall at least 36 inches off the floor and within 3 feet of a 120 VAC electrical outlet. Secure to the wall studs or anchor securely to a block wall. Make sure to keep all sides of the power unit clear of obstructions by at least 12“.
  • Page 5 TROUBLE-SHOOTING (CONTINUED) NOTE: The manufacturer assumes no responsibility for injury or damage associated with disassembly or modification of the power unit. Consult with customer service before attempting any disassembly. PUMP DOES NOT RUN OR HUM. Power Unit Fuse/Overload Protection tripped or loose. Check / replace fuse. Water level in pit may be too low to activate switch.
  • Page 6 You MUST retain your original purchase receipt along with this manual. In the event that you need to exercise a warranty claim, you MUST send a copy of the purchase receipt along with the material or correspondence. Please email support@pumpspy.com for return authorization and instructions.
  • Page 7 (the “Warranty Period”). During the warranty period, PumpSpy will repair or replace at no cost to you, to correct such defects in products found upon examination by PumpSpy to be defective in materials or workmanship.

Table of Contents