Explo X2-Wave-Flame Maintenance Instruction page 6

5 GX3 SFX TORCH
5.1 STORAGE
Depressurize the System of every effect device after every show and again before moving them

into storage to avoid wearing out sealing- and moving parts!
Charge batteries before moving the devices into storage and then charge at least once every 2

months!
Use a toothbrush or scour pads to clean the electrodes!

Clean the effect devices with rubbing alcohol to get rid of dirt or grime!

Remove aerosol cans and open the aerosol-adapters valves to avoid storing under pressure!

Store at room temperature! Avoid large temperature changes! Do not store close to heating

devices! Store at temperatures between 10°C-35°C!
5.2 BEFORE EVERY SHOW
Check safety distances and adjust accordingly!

Prepare a CO2 Extinguisher just in case!

Check the devices' function, by using it without any aerosol cans connected to hear the solenoid

valve and see the spark on the tips of the electrode!
Connect aerosol cans and test fire the device to ensure function.

6
Charge the devices!

Instruct the user on how to handle the device properly and how to react in emergency situations.

5.3 AFTER EVERY SHOW
Check devices for damages and mark faulty ones with tape and a description of the issue!

Close the blue aerosol valves and remove the aerosol cans, then fire the device in a safe

environment until no more flame is expelled!
Clean the devices when they are dirty!

Never look down into the nozzle of the GX3 when checking the spark!