Explo X2-Wave-Flame Maintenance Instruction page 3

2 X2 WAVEFLAME / WAVEFLAME HEAD AND LPS
2.1 STORAGE
Depressurize the System of every effect device after every show and again before moving them

into storage to avoid wearing out sealing- and moving parts!
Clean the effect devices with rubbing alcohol to get rid of unburned fuel and dirt or grime!

Use a toothbrush or scour pads to clean the electrodes!

Store the X2 Wave Flames / LPS with at least 1Liter of fuel in the tank to avoid damages when

pumping up the device and having forgotten to add more fuel!
Run the system at least once a month to ensure proper lubrication and avoid drying out of the

pump system!
When running the system, if possible, shoot the devices to ensure proper
2.2 BEFORE EVERY SHOW
Check safety distances and adjust accordingly!

When changing nozzles, only fasten them hand tight!

Prepare a CO2 Extinguisher just in case!

Check the devices by firing them with the chosen controller for the upcoming show!

Check if enough liquid is in the tank and prepare more canisters to fast swap if necessary!

2.2.1 FOR DMX:
Avoid DMX cables and Power cables running alongside each other.

Always use DMX terminators on the last device in a DMX chain.

2.2.2 FOR RC:
Check connection of transmitter and receivers on location!

Check if the show has been transmitted to all receivers!

2.3 AFTER EVERY SHOW
Check devices for damages and mark faulty ones with tape and a description of the issue!

Depressurize the system by disarming the devices!

Clean the devices when they are dirty!

function!
3