Explo X2-Wave-Flame Maintenance Instruction page 4

3 X2 POWERFLAME
3.1 STORAGE
Depressurize the System of every effect device after every show and again before moving them

into storage to avoid wearing out sealing- and moving parts!
Clean the effect devices with rubbing alcohol to get rid of unburned fuel and dirt or grime!

Use a toothbrush or scour pads to clean the electrodes!

Check if the pressure inside is "0" before moving devices into storage!

3.2 BEFORE EVERY SHOW
Check safety distances and adjust accordingly!

Prepare a CO2 Extinguisher just in case!

Check the devices by firing them with the chosen controller for the upcoming show!

Check the devices and hoses for leakage!

3.2.1 FOR DMX:
Avoid DMX cables and Power cables running alongside each other.

Always use DMX terminators on the last device in a DMX chain.

4
3.2.2 FOR RC:
Check connection of transmitter and receivers on location!

Check if the show has been transmitted to all receivers!

3.3 AFTER EVERY SHOW
Check devices for damages and mark faulty ones with tape and a description of the issue!

Disconnect the manifold from the Nitrogen and Propane tank!

Open the inlet quick coupling to avoid pressurized gas to remain in the tube system!

Empty the tank completely either by shooting until no more flame is expelled, or by using

channel 24 on the transmitter to discharge the unburned gas from the tank!
Clean the devices when they are dirty!

Make sure no one is in the vicinity of the device when emptying the tank
and only do this outdoors!