Husqvarna 325iRJ Operator's Manual
Husqvarna 325iRJ Operator's Manual

Husqvarna 325iRJ Operator's Manual

Hide thumbs Also See for 325iRJ:

Advertisement

Quick Links

325iRJ
EN
Operator's manual
8-25

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 325iRJ and is the answer not in the manual?

Questions and answers

Summary of Contents for Husqvarna 325iRJ

  • Page 1 325iRJ Operator's manual 8-25...
  • Page 8: Table Of Contents

    Contents Introduction..............8 Transportation, storage and disposal......21 Safety................9 Technical data.............. 21 Assembly..............16 Accessories..............23 Operation..............17 Declaration of Conformity..........24 Maintenance..............19 Appendix ..............26 Troubleshooting............20 Introduction Product description Note: National or local regulations can set limit to the operation of the product.
  • Page 9: Safety

    and regulations, and New South Wales (Fig. 5) Rated voltage, V legislations "Protection of the Environment Operations (Noise Control) Regulation (Fig. 6) Direct current. 2017". The guaranteed sound power level Technical of the product is specified in (Fig. 7) The product agrees with the applicable data on page 21 .
  • Page 10 Work area safety a rotating part of the machine may result in personal injury. • Keep work area clean and well lit. Cluttered or dark • Do not overreach. Keep proper footing and balance areas invite accidents. at all times. This enables better control of the •...
  • Page 11 Battery tool use and care • Follow instructions for changing accessories. Improperly tightened blade securing nuts or bolts • Recharge only with the charger specified by the may either damage the blade or result in it becoming manufacturer. A charger that is suitable for one type detached.
  • Page 12 • Use extreme caution when cutting brush and • Always ensure that ventilation openings are kept saplings. The slender material may catch the blade clear of debris. and be whipped toward you or pull you off balance. • Check that the trimmer head is completely attached •...
  • Page 13 cover damage or liability caused by the use of non- • Make sure that no clothes or parts of the body authorized accessories or replacement parts. come in contact with the cutting attachment when the product is activated. Keep the product below •...
  • Page 14 • If you are approached by another person while carried out professionally. If you need further information operating the machine, switch the machine off. please contact your nearest servicing dealer. There is an increased risk of injury to other persons WARNING: being struck by the moving blade in the event of Never use a product with...
  • Page 15 To do a check of the cutting attachment guard Accessories on page 23 . Make sure that the cutting attachment is sharpened WARNING: correctly. A cutting attachment that is not Do not use a cutting sharpened correctly increases the risk of attachment without an approved and blade thrust.
  • Page 16: Assembly

    A cutting attachment that is attached incorrectly can • Do not clean the battery or the battery charger with cause injury or death. water. Strong detergent can cause damage to the plastic. • If a harness is supplied with the attachment, the harness must be correctly attached to the product.
  • Page 17: Operation

    Make sure that there are no cracks at the bottom of the grass blade teeth or by the center hole of the blade. Replace the blade if it is damaged. WARNING: Only use Husqvarna (Fig. 41) original batteries with the product. •...
  • Page 18 To clear grass with a grass blade • Hold the product on the right side of your body. • Keep the cutting attachment below waist level. 1. Grass blades and grass cutters must not be used on • Always keep the product attached to the harness. woody stems.
  • Page 19: Maintenance

    Make sure that the bevel gear is filled correctly with grease, see on page 21 . If not, use Husqvarna bevel gear grease. Make sure that the air intake of the motor is not dirty. Clean the air intake with compressed air.
  • Page 20: Troubleshooting

    5. If the grease level is too low fill the bevel gear with To sharpen the grass knife and grass Husqvarna bevel gear grease. Fill slowly and turn blade the drive shaft as you apply the bevel gear grease, stop at the correct level (B).
  • Page 21: Transportation, Storage And Disposal

    • Use the battery charger only when the surrounding temperature is between 5°C/41°F and 40°C/104°F. Technical data Technical data 325iRJ Motor Motor type BLDC (brushless) 36V Speed of output shaft, 1/min 5800 Cutting width, mm...
  • Page 22 325iRJ Sound power level, guaranteed L dB (A) Noise levels Equivalent sound pressure level at the operator's ear, measured according to ISO 22868, dB (A): Equipped with trimmer head (original) Vibration levels Vibration levels at handles, measured according to ISO 22867, m/s Equipped with trimmer head (original), Front/Rear, m/s 2.1/2.0...
  • Page 23: Accessories

    Accessories Accessories Approved accessories Accessory type Cutting attachment guard, art. no. Centre hole in blades/knives, Ø 25.4 mm Output shaft thread M10 Multi 255-3 (Ø 255, 3 teeth) 536 17 43-01 Grass blade/grass knife Grass 255-4 (Ø 255, 4 teeth) 536 17 43-01 T35, T35x (Ø...
  • Page 24: Declaration Of Conformity

    Declaration of Conformity EU Declaration of conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Battery-operated brushcutter / grass trimmer Brand Husqvarna Type / Model 325iRJ Identification Serial numbers dating from 2023 and onwards...
  • Page 25 UK Declaration of conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Battery-operated brushcutter / grass trimmer Brand Husqvarna Type / Model 325iRJ Identification Serial numbers dating from 2023 and onwards...
  • Page 26: Appendix

    T35, T35x Li-ion 8,5 m 10 cm 4" 4,3 m "Click" 15 cm 6" 1858 - 006 - 17.04.2024...
  • Page 27 1858 - 006 - 17.04.2024...
  • Page 28 Original instructions 1144075-26 2024-04-29...

Table of Contents