Ide Configuration - ASROCK K8NF4G-SATA2 R2.0 User Manual

3.3.4 IDE Configuration

3.3.4 3.3.4 IDE Configuration IDE Configuration IDE Configuration
3.3.4 3.3.4 IDE Configuration
BIOS SETUP UTILITY
Advanced
IDE Configuration
OnBoard IDE Controller [Both]
OnBoard SATAII Controller [Enabled]
SATAII Operation Mode [non-RAID]
Primary IDE Master [Hard Disk]
Primary IDE Slave [Not Detected]
Secondary IDE Master [ATAPI CDROM]
[Not Detected]
Secondary IDE Slave
SATAII 1 [Not Detected]
SATAII 2 [Not Detected]
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
OnBoard IDE Controller
You may enable either the primary IDE channel or the secondary IDE channel.
Or you may enable both the primary and the secondary IDE channels by
selecting [Both]. Set to [Disabled] will disable the both. Configuration options:
[Disabled], [Primary], [Secondary], [Both].
OnBoard SATAII Controller
Use this item to enable or disable the "OnBoard SATAII Controller" feature.
SATAII Operation Mode
Use this item to adjust SATAII Operation Mode. The default value of this
option is [non-RAID]. If you want to operate RAID function on SATA / SATAII
HDDs, please select [RAID].
IDE Device Configuration
You may set the IDE configuration for the device that you specify. We will
use the "Primary IDE Master" as the example in the following instruction,
which can be applied to the configurations of "Primary IDE Slave", "Sec-
ondary IDE Master", and "Secondary IDE Slave" as well.
DISABLED: disables the
integrated IDE
Controller.
PRIMARY: enables only
the Primary IDE
Controller.
SECONDARY: enables
only the Secondary IDE
Controller.
BOTH: enables both IDE
Controllers.
Select Screen Select Screen
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
3 0 3 0 3 0 3 0 3 0