ASROCK K8NF4G-SATA2 R2.0 User Manual page 26

PCIE Frequency (MHz)
Use this option to adjust PCIE frequency. The range is from 70MHz to
150MHz. The default value is [100].
Boot Failure Guard
Enable or disable the feature of Boot Failure Guard.
CPU Spread Spectrum
This feature will be set to [Center Spread] as default. Configuration
options: [Disabled], [Center Spread], and [Down Spread].
PCIE Spread Spectrum
This feature will be set to [Enabled] as default. Configuration
options: [Disabled], and [Enabled].
SATA Spread Spectrum
This feature will be set to [Enabled] as default. Configuration
options: [Disabled], and [Enabled].
HT Spread Spectrum
This feature will be set to [Center Spread] as default. Configuration
options: [Disabled], [Center Spread], and [Down Spread].
Cool 'n' Quiet
Use this item to enable or disable AMD's Cool 'n' Quiet
Processor Maximum Multiplier
It will display Processor Maximum Multiplier for reference.
Processor Maximum Voltage
It will display Processor Maximum Voltage for reference.
Multiplier/Voltage Change
This item is set to [Auto] by default. If it is set to [Manual], you may adjust the
value of Processor Multiplier and Processor Voltage. However, it is recom-
mended to keep the default value for system stability.
BIOS SETUP UTILITY
Advanced
CPU Configuration
Overclock Mode [Auto]
CPU Frequency (MHz) [200]
PCIE Frequency (MHz) [100]
Boot Failure Guard [Enabled]
CPU Spread Spectrum [Center Spread]
PCIE Spread Spectrum [Enabled]
SATA Spread Spectrum [Enabled]
HT Spread Spectrum [Center Spread]
Cool' n' Quiet [Enabled]
Processor Maximum Multiplier x11
Processor Maximum Voltage 1.550 V
Multiplier/Voltage Change [Manual]
[x8]
Processor Multiplier
[1.500V]
Processor Voltage
[Auto]
Memory Clock
[Disabled]
Flexibility Option
[Auto]
Bank Interleaving
[4 Beats]
Burst Length
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
TM
technology.
If AUTO, multiplier and
voltage will be left at the
rated frequency/voltage. If
Manual, multiplier and
voltage will be set based
on User Selection in Setup.
Select Screen Select Screen
Select Item Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
2 6 2 6 2 6 2 6 2 6