Table of Contents
Advertisement
Serial ATA (SATA)
Power Cable
connect to the SATA HDD
(Optional)
USB 2.0 Header
(9-pin USB67)
(see p.9, No. 19)
USB 2.0 Header
(9-pin USB_H45)
(see p.9, No. 20)
Infrared Module Header
(5-pin IR1)
(see p.9, No. 30)
Internal Audio Connector
(4-pin CD1)
(see p.9, No. 26)
Front Panel Audio Header
(9-pin AUDIO1)
(see p.9, No. 28)
Bridge Fan Connector
(3-pin NB_FAN1)
(see p.9, No. 16)
power connector
connect to the
power supply
USB_PWR
P-6
P+6
GND
DUMMY
1
GND
P+7
P-7
USB_PWR
USB_PWR
P-5
P+5
GND
1
GND
P+4
P-4
USB_PWR
IRTX
+5V
DUMMY
1
GND
IRRX
CD-R
GND
GND
CD-L
GND
+5VA
BACKOUT-R
1
GND
AUD-OUT-R
MIC-POWER
MIC
GND
+12V
CHA_FAN_SPEED
Please connect the black end of
SATA power cable to the power
connector on each drive. Then
connect the white end of SATA
power cable to the power
connector of the power supply.
ASRock 8CH I/O provides you
4 ready-to-use USB 2.0 ports on
the rear panel. If the rear USB
ports are not sufficient, this
USB 2.0 header is available to
support 2 extra USB 2.0 ports.
ASRock 8CH I/O
4 ready-to-use USB 2.0 ports on
DUMMY
the rear panel. If the rear USB
ports are not sufficient, this
USB 2.0 header is available to
support 2 extra USB 2.0 ports.
This header supports an optional
wireless transmitting and
receiving infrared module.
This connector allows you to
receive stereo audio input from
sound sources such as a CD-
ROM, DVD-ROM, TV tuner card,
or MPEG card.
This is an interface for the front
panel audio cable that allows
BACKOUT-L
convenient connection and
control of audio devices.
AUD-OUT-L
Please connect the Bridge fan
cable to this connector and
match the black wire to the
ground pin.
TM
provides you
Advertisement
Table of Contents
