DELTA DORE TYMOOV Solar 5 SO Manual
  1. Manuals
  2. Brands
  3. DELTA DORE Manuals
  4. Engine
  5. TYMOOV Solar 5 SO
  6. Manual
DELTA DORE TYMOOV Solar 5 SO Manual

DELTA DORE TYMOOV Solar 5 SO Manual

Range of solar-powered wireless tubular motors
Hide thumbs Also See for TYMOOV Solar 5 SO:
Table of Contents

Advertisement

Quick Links

Download this manual
TYMOOV Solar
5 SO / 10 SO
EN
Range of solar-powered wireless tubular motors

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TYMOOV Solar 5 SO and is the answer not in the manual?

Questions and answers

Related Manuals for DELTA DORE TYMOOV Solar 5 SO

Summary of Contents for DELTA DORE TYMOOV Solar 5 SO

  • Page 1 TYMOOV Solar 5 SO / 10 SO Range of solar-powered wireless tubular motors...
  • Page 2 They are only compatible with remote controls from the - Before installing the motor, remove all superfluous cords and take DELTA DORE X3D range: TYXIA 1701, TYXIA 2331 and TYXIA out of service any equipment not required for the motor to operate.
  • Page 3 France - Weighted noise pressure level A: LpA ≤ 70 dB(A). Par la présente, DELTA DORE déclare sous sa seule responsabilité que le produit ci-dessus est en conformité avec la législation d'harmonisation de l'Union Européenne : Hereby, DELTA DORE declares under its sole responsibility that the above device is in conformity with the relevant...

  • Page 4: Table Of Contents

    Contents 1/ Technical characteristics 1/ Technical characteristics .................7 • Power supply: 12 Vcc TYMOOV solar motors can only be used with the DELTA DORE batteries supplied 2/ Motor fitting ....................8 2.1 Crown and wheel assembly ................. 8 with the motors: 2.2 Assembly in the tube ....................

  • Page 5: 2/ Motor Fitting

    2/ Motor fitting 2.3 Motor head position • Never strike the motor head or output shaft to fit the motor into the tube. The motor head should be positioned on the bracket so that the cable outlet is at Never pierce the tube when the motor is installed. the bottom in relation to the horizontal.

  • Page 6: 3/ Connection

    3/ Connection 4/ Starting up for the first time The motor is supplied with a H05VVF power cable, This cable cannot be installed When switched on for the first time, the motor runs a cycle to warn that no outdoors, unless it is inside a UV-resistant duct. transmitter is paired.

  • Page 7: Stop Settings

    4/ Starting up for the first time 4.3 Stop settings 4.3.1 Storing 2 automatic stops You can use Auto mode if there are both upper and lower physical stops. The motor will automatically detect its end of travel distances. If there are no upper physical stops and/or automatic locks, you must set the end of ❶...
  • Page 8 4/ Starting up for the first time 4.3.2 Store 1 manual stop + 1 automatic stop 4.3.3 Store 2 manual stops ❶ Position the shutter ❶ Position the shutter Progress stepwise Progress stepwise Press the button to move the shutter to the To progress stepwise, briefly press the Press the button to move the shutter to the...

  • Page 9: 5/ Modifying Stops

    5/ Modifying stops 7/ Linking a smoke detector directly to the motor The stops must first be removed then recorded again for them to be modified. Remove them by proceeding as follows: You want to control the opening of roller shutters if smoke is detected. >...

  • Page 10: 9/ Obstacle Detection

    9/ Obstacle detection 10/ Erasing one or more pairings 10.1 Erasing the pairing of the remote control with the motor The motors of the TYMOOV range include the obstacle detection feature. This fully protects the roller shutter mechanism. - Remove the front panel of the remote control. After locking on an obstacle, the motor reverses direction by about 15 cm.

  • Page 11: 12/ Pairing With An Alarm Control Unit

    12/ Pairing with an alarm control unit The pairing of the motor with an alarm control unit enables: 12.2 Defining the motor’s operating mode - the anti-intrusion function attempt to raise the shutter), - the surveillance stop/start report. Alarm Stopping activation of the alarm 12.1 Pairing the wireless motor...

  • Page 12: 13/ Your Remote Control Is Lost Or Not Functioning

    13/ Your remote control is lost or not functioning 15/ Troubleshooting • The motor does not work: These procedures are used to set the motor to Awaiting pairing mode for a new - Check that the wiring corresponds to the diagrams in the "Connection" chapter. control unit (Tyxia 1701, 2331, TYDOM etc.) when the remote control of the - Check the power supply within the network.
  • Page 13 www.deltadore.com...

This manual is also suitable for:

Tymoov solar 10 so10s1p10s1p122800212280022

Table of Contents