Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DELTA DORE Pack TYMOOV 30 FB
Summary of Contents for DELTA DORE Pack TYMOOV 30 FB
- Page 1 Pack TYMOOV 30 FB Wired roller shutter motor pack...
- Page 2 Recommendations WARNING: Important safety instructions - The operating device for a switch without a lock must be in direct Incorrect installation can result in serious injuries. view of the driven part, but away from the moving parts. It must be Follow all instructions and retain these installation instructions for installed at a height of at least 1.5 m.
- Page 3 20 minutes. To operate again for a period of 4 minutes, the motor must have returned to room temperature. DELTA DORE hereby declares that the motorised drive unit covered by these instructions is compliant with the essential requirements of the Machinery...
-
Page 4: Table Of Contents
Technical specifications Contents • Power supply: 230V - 50 Hz +/- 10% • Class I insulation 1/ Installation ....................8 • Operating time: 4 minutes 1.1 Installing the tube ..................... 8 1.2. Motor.fitting ......................10 • Electrical power ratings: 1.3 Installing the fasteners ..................12 TYMOOV 10FB : 112 W 2/ Connection ....................14 TYMOOV 20FB : 145 W... -
Page 5: 1/ Installation
1/ Installation 1.1 Installing the tube ❻ Determine the length of the new tube. - Measure the distance between the 2 mounts. - Calculate the length of the tube. ❶ Lower the roller shutter completely. Motor mount Bearing mount Coffre tunnel Coffre menuisé... -
Page 6: Motor.fitting
1/ Installation 1.2.3 Motor head position 1.2 Motor fitting The motor head must be positioned on the support as such that the cable outlet is in the lower part relative to the horizontal. • Never strike the motor head or output shaft to fit the motor into the tube. Never pierce the tube when the motor is installed. -
Page 7: Installing The Fasteners
1/ Installation 1.2.5 Telescopic assembly Attach the fasteners to the tubes. Drill Ø 4 mm holes Attach the fasteners using the screws provided. Use the holes marked 1 and 2. Tube 2 Tube 1 Use the screws provided. The screws must not be in contact with the motor. -
Page 8: 2/ Connection
2/ Connection 3/ Setting stops The electrical wiring must comply with EN, IEC and national institute standards (e.g. You can connect Tyxia 5630 micromodules to the Tymoov xFB motors. NF C15-100 for France). They must be connected after the setting of the stops. In all instances, it must still be possible to switch off the power supply using an omnipolar device in accordance with the applicable installation requirement. -
Page 9: Adjusting Screw Selection Table
3/ Setting stops 4/ Troubleshooting 3.1 Adjusting screw selection table If the motor is not working: Interior winding Exterior winding - Check that the wiring corresponds to the diagrams in the «Connection» chapter. - Check the power supply within the network. Left mounted Right mounted Left mounted... - Page 10 www.deltadore.com...
Need help?
Do you have a question about the Pack TYMOOV 30 FB and is the answer not in the manual?
Questions and answers