Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DELTA DORE TYMOOV 6F2
Summary of Contents for DELTA DORE TYMOOV 6F2
- Page 1 TYMOOV 6F2 - 10F2 - 20F2 Tubular Motor range...
- Page 2 Recommendations WARNING: Important security instructions - The operating device of an unlockable switch must be in direct view Incorrect installation may cause severe injury of the driven part, but kept away from the moving parts. It must be Follow all the instructions and keep this installation guide in a safe installed at a height of at least 1.5 m.
- Page 3 - A-weighted sound pressure level: LpA ≤ 70 dB(A). - Cables going through a metal wall must be protected and isolated by DELTA DORE a sleeve. 35270 - BONNEMAIN - France The TYMOOV xF2 cable can be disassembled.
-
Page 4: Table Of Contents
1.1 Crown and wheel assembly ................. 8 • Electrical powers: 1.2 Assembly in the tube ....................8 TYMOOV 6F2 : 40 W 1.3 Motor head position ....................9 1.4 Attaching the motor to the mount ..............9 TYMOOV 10F2 : 50 W TYMOOV 20F2 : 70 W 2/ Connection ....................10... -
Page 5: 1/ Motor Fitting
1/ Motor fitting • Never hit the motor head or output shaft to fit the motor into the tube. 1.3 Motor head position Never pierce the tube when the motor is installed. The motor head must be positioned on the mount such that the cable outlet is in •... -
Page 6: 2/ Connection
2/ Connection 3/ Stop settings The electrical wiring must comply with EN, IEC and national institute standards for You can connect Tyxia 5630/5730 nanomodules to Tymoov hard-wired motors installation (e.g.: NF C15-100 for France). (Tyxia 5630 recommended). In all cases, it must still be possible to switch off the power supply by using an Make sure they are compatible by checking that the manufacturing date code is omnipolar device in accordance with the applicable installation requirement. -
Page 7: Setting 2 Automatic Stops
3/ Stop settings 3.3 Setting 1 manual stop + 1 automatic stop 3.2 Setting 2 automatic stops ❶ Automatic upper stop ❶ Manual upper stop Upper physical stop Stop on shutter blade Lower physical Press and hold the stop Press and hold the button until the shutter is in the required button briefly until the position. -
Page 8: Setting 2 Manual Stops
3/ Stop settings 4/ Clearing stops 4.1 By wiring 3.4 Setting 2 manual stops - Switch off the power supply to the system. ❶ Manual upper stop Blue Brown Black - Connect the black and brown wires to 3 x 0.75 mm the raise phase and set the switch to the ‘raise’... -
Page 9: 5/ Troubleshooting
5/ Troubleshooting If the motor is not working: - Check that the wiring corresponds to the diagrams in the “Connection” chapter. - Check the power supply in the network. - Check that the motor is not in thermal protection mode; just wait a few minutes for it to cool down. - Page 10 www.deltadore.com...
Need help?
Do you have a question about the TYMOOV 6F2 and is the answer not in the manual?
Questions and answers