StarLab Mixer HC Quick Start Manual

This is your
quickstart manual.
These short instructions may only be used by trained
personnel who are familiar with the operating manual
and the device. Observe the safety precautions.
Set temperature, mixing frequency and time
Switch off "PROG." or "INTERVAL MIX" function (see below).
Use
Press
After time has elapsed, mixing ends, however, temperature control continues.
Interval Mix
To switch interval mix on/off:
Press
To set up interval mix:
Use
Press
Use
Press
Use
Press
Passionate for science.
Mixer HC
to set temperature, mixing frequency and/or time. To use the unit
without any of these three functions, press the arrow key until off
appears.
to start the process. To finish the process, press "START/STOP"
again.
for longer than 2 seconds. Control light will light when the function
is activated.
to set temperature and total time.
to activate mixing phase.
to set the duration of the mixing phase.
to set pause phase.
to set the duration of the pause phase.
to start the interval function. The unit alternates between mixing
and pausing until total time has elapsed. Temperature control is
then continued.