Wiring Diagrams - Assa Abloy Corbin Russwin SN Series Installation Instructions Manual

Installation Instructions
SN200/210 ED5000 Series Exit Device
With MELR
Product
1-Black
12VDC
(Reader)
SN200 (UL294)
SN200
NEG
SN210
*Diagrams on following pages
If your lock is configured with End of Line Resistors, reference instruction sheet FM406 for the wiring of
RX & DPS outputs.
Wiegand Operation Mode:
• Red LED 'ON' when powered.
• Presenting a compatible credential causes LED to briefly turn green and then return to red state.
UL294 / TAMPER Configuration:
• Connect Yellow TAMPER wire from ElectroLynx cable to desired EAC panel control line.
Reference Diagram #1.
• As appropriate, use the configuration card to activate desired mode on reader.
PIN 8 (Yellow – TAMPER)
PIN 6 (Blue – RX COM)
PIN 4 (Green – DATA_0)
PIN 2 (Red – Reader POS)
PIN 1 (Black – Reader NEG)
PIN 3 (White – DATA_1)
PIN 5 (Orange – RX NO)
PIN 7 (Brown - EGND)
Non-UL294 Configuration:
• Connect GREEN_LED input to switch controlled by panel. Shorting GREEN_LED to READER_NEG (Black)
with panel switch will override reader LED to keep it green.
PIN 8 (Yellow – GREEN_LED)
PIN 6 (Blue – RX COM)
PIN 4 (Green – DATA_0)
PIN 2 (Red – Reader POS)
PIN 1 (Black – Reader NEG)
PIN 3 (White – DATA_1)
PIN 5 (Orange – RX NO)
PIN 7 (Brown - EGND)
Copyright © 2020-2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of
ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.

5) Wiring Diagrams

8 PIN CONNECTOR
2-Red 3-White 4-Green
ACCESS CONTROL DEVICES: SN200/210 Lockset, ElectroLynx wire Color / Function assignments
Communication
Type
WIEGAND WIEGAND
DATA_1 DATA_0
POS
OSDP OSDP
RS-485B RS-485A
5-Orange 6-Blue 7-Brown
RX RX EGND
NO COM EGND
PIN 4 (Tan –DPS COM )
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
PIN 3 (Pink – DPS NC)
PIN 4 (Tan –DPS COM )
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
PIN 3 (Pink – DPS NC)
7
4 PIN CONNECTOR
8-Yellow 1-Violet 2-Gray
12/24 VDC
Function*
(LOCK RELAY)
TAMPER
GREEN LED
NEG POS
n/a
Note: NC= Normally Closed
NO= Normally Open
3-Pink 4-Tan
DPS DPS
NC COM