Assa Abloy Corbin Russwin SN Series Installation Instructions Manual page 17

Installation Instructions
SN200/210 ED5000 Series Exit Device
With MELR
7. Install Outside Trim Assembly (Rim/CVR/SVR):
a. Make sure tailpiece is oriented vertically.
b. Feed trim wire harness through wire harness hole (Fig. 7).
c. Mount trim assembly to door pulling slack wire towards device side of door.
Note: Be careful not to pinch wire harness.
d. When mounting trim, lift tailpiece to pass through hole on device side (Fig. 7).
Note: Ensure tailpiece is still oriented vertically.
e. Fasten trim assembly to door using (2) 1/4-20 oval head screws and (2) finish washers (Fig. 7).
Note: Finger tighten only.
Caution: When installing
trim, pull wires completely
through door to avoid
contacting motor
assembly, as this may
cause loss of function.
Copyright © 2020-2023 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of
ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
6) Installation Instructions (Continued)
Trim
Wire
Harness
Fig. 7
17
Reader
Harness
Wire
Harness
Hole