Appendix A: Interface 1010 Specifications; Control Amplifier - Gamry Instruments Interface 1010 Operator's Manual

Appendix A: Interface 1010 Specifications

All specifications are at an ambient temperature of 22°C, with the Interface 1010 powered using the external
power supply shipped with the unit, a standard shielded 60 cm cell cable, and the cell enclosed in a Faraday
shield. All specifications are after software calibration.
A numbered note qualifies many of the specifications. Many of these notes describe the method used to
measure a specification. The notes are found at the end of this appendix.
All specifications are subject to change without notice.
System
Cell Connections
Floating
Maximum Current
Current Ranges
Current Ranges (with Gain)
Minimum Current Resolution
Minimum Voltage Resolution
Maximum Applied Voltage
Rise Time
Noise and Ripple
Minimum Timebase
Maximum Timebase
Minimum Potential Step
EIS Measurement
Frequency Range
Impedance Accuracy
AC Amplitude

Control Amplifier

Compliance Voltage
Output Current
Interface 1010 Specifications
Interface
1010T
2, 3, 4
Yes
Typ ±100
6
8
Typ 0.3 -12
Typ 1
Typ ±5
Typ 1
Max 20
Typ 1000
Typ 750
Typ 12.5
Interface
1010T
Min 10 µHz
Max 20 kHz
Typ 99%
Max 2.33
Typ ±20 (@ 1 A)
Min ±1000
67
Interface Interface
1010B 1010E
2, 3, 4 2, 3, 4
Yes Yes
±1000 ±1000
9 9
11 11
3.3 -15 3.3 -15
1 1
±12 ±12
1 1
20 20
10 10
750 750
12.5 12.5
Interface Interface
1010B 1010E
10 µHz 10 µHz
20 kHz 2 MHz
99% see Accuracy
Contour Plot
2.33 2.33
V
mA
mA
A
µV
V
µs
µV rms
µs
s
µV
V rms
Note 1
Note 2