Label Sheet Provided With Each Interface 1010; Procedure To Change A Label - Gamry Instruments Interface 1010 Operator's Manual

Insert simple paper labels in an area behind the clear plastic outer layer of the front panel. The paper is behind
the plastic, so it is not affected by the lab environment. Best of all, you can edit or print the labels so personal
labels, like Bob's Stat, are also possible.
There are several versions of the Interface 1010. If you upgrade from an Interface 1010B to an Interface 1010E,
you may also remove the B label from the top, and replace it with an E.

Label Sheet Provided with Each Interface 1010

Every Interface 1010 is shipped with a preprinted label sheet containing:
• Instructions on how to change the label
•
The first eight letters of the Greek alphabet (alpha through theta)
•
The eight planets in the solar system (Mercury through Neptune)
•
Several blank white labels
•
Pstat 1 through Pstat 16 on a blue background
• Pstat 1 through Pstat 16 on a red background
You can cut any of these labels from the sheet and insert as the Interface 1010 Customization Label. The white
labels are provided to allow you to handwrite a label.

Procedure to Change a Label

These instructions apply to all current members of the Gamry Instruments Interface family. Don't be confused
because some of the pictures were taken using an Interface 1010.
1) If you are making a custom-printed label, edit the Excel
above. If you are using the Gamry-supplied label sheet, identify the location on the sheet where the
new label is found.
2) If you are writing by hand on a blank label, do it now.
3) Use scissors to cut out the new label. Cut white labels on the black lines.
4) Power down the Interface 1010 that is receiving the new label.
5) Remove the instrument's rubber front bezel (the rubber frame around the front panel). No tools are
required, see Figure 3-4.
Installation – The Interface 1010 Customization Label
file and print a label sheet as described
®
27