Webasto MultiControl Quick Start Manual page 5

10 Statutory regulations governing installation 10 Statutory regulations governing installation
Regulations Regulations Type-approval numbers for MultiControl | SmartControl
Electromagnetic compa- Electromagnetic compa-
04 7319 MultiControl | SmartControl
ECE R10
tibility tibility
NOTE NOTE
The provisions of these regulations are binding within the scope of EU Regulation The provisions of these regulations are binding within the scope of EU Regulation
2018/858 and should also be observed in countries where there are no special regulati- 2018/858 and should also be observed in countries where there are no special regulati-
ons. ons.
IMPORTANT IMPORTANT
Failure to follow the installation instructions will result in the invalidation of the type Failure to follow the installation instructions will result in the invalidation of the type
approval for the heater and therefore invalidation of the general homologation of the approval for the heater and therefore invalidation of the general homologation of the
vehicle. vehicle.
NOTE NOTE
For vehicles with an EU type approval, an entry is not required in accordance with § 19 For vehicles with an EU type approval, an entry is not required in accordance with § 19
section 4 of appendix VIII b of StVZO. Country-specific registration regulations must be section 4 of appendix VIII b of StVZO. Country-specific registration regulations must be
complied with. complied with.
11 Installation 11 Installation
Detailed information can be found in the operating and installation instructions. Detailed information can be found in the operating and installation instructions.
The documents are stored on the DVD included in delivery. The documents are stored on the DVD included in delivery.
Install and connect wiring harness, see Section „12 Electrical Connections". Install and connect wiring harness, see Section „12 Electrical Connections".
X X
Connect and install MultiControl | SmartControl. Connect and install MultiControl | SmartControl.
X X
Type-approval numbers for MultiControl | SmartControl
04 7319 MultiControl | SmartControl
ECE R10
12 Electrical Connections 12 Electrical Connections
DANGER DANGER
Incorrect handling Incorrect handling
Cables damaged on sharp edges can cause short-circuits. Fit protectors on sharp Cables damaged on sharp edges can cause short-circuits. Fit protectors on sharp
edges. edges.
Connector designation Connector designation
Con. Description Con.
4 4
W Bus / Low
1 1 1 1 1 1
3 3
1 Switch / Diag- 1
nostics
2 2
SAU1 switch
2 2
output
3 KL30 3
4 KL31 4
Description Remarks Remarks
The connection is configured The connection is configured
differently depending on the differently depending on the
heater selected. Please note heater selected. Please note
W Bus / Low that there is no W-bus on this that there is no W-bus on this
Switch / Diag- line for heaters with analogue line for heaters with analogue
nostics control. W-bus diagnostics are control. W-bus diagnostics are
only possible with a W-bus hea- only possible with a W-bus hea-
ter connected or with a UniBox ter connected or with a UniBox
connected. connected.
SAU1 switch
max. switching current 500 mA max. switching current 500 mA
output
KL30 Plus+ Plus+
KL31 Earth- Earth-
13 Dimensions 13
48
5
15
10