Arkon MAGRM079 Manual

MAGRM079 | Magnetic Car Phone Holder with Suction Mount
SPHDMAGKIT
Install the Magnet Mount onto the 17mm Ball to 25mm Ball Adapter
First, detach the tightening ring from the magnetic holder and position
it onto the 17mm ball adapter. Next, insert the 17mm ball adapter into
the rear part of the magnetic holder. Finally, twist the tightening ring
clockwise to secure it in place.
WARNING
CHOKING HAZARD - Keep out of reach from children under 8 yrs. as they can choke or suffocate on parts included with this system
WARNING
Arkon ® is not responsible for any damages caused to your device or yourself due to the installation or use of this mount. Do not install Arkon
of vehicles. Arkon ® assumes no responsibility or liability for injury or death as a result of failure to install in a safe location. Arkon
product, or people due to the installation or use of this product.
SP25MM17 XACP
SPRM079 SP-RM250
USA (800) 841-0884
INT'L (626) 254-9005
Monday - Friday 9 am - 5 pm PST
Includes:
1 – Magnet Mount Kit for Phones
1 – 25mm Ball to 17mm Ball Adapter
1 – Robust™ Series Standard Mount Shaft
1 – Sticky Suction Base with 25mm Ball
1 – Alcohol Pad
(XACP)
Important: Clean the application surface with the alcohol pad and
make sure it is free of dirt, dust, and grease before installing the
mounting hardware.
Assembling the Components
To detach the knob from the shaft arm, turn it counter-
clockwise. Insert the 25mm ball from the suction base to the
shaft arm and the 25mm ball from the Magnetic mount.
® is not responsible for any damages caused to vehicles,
arkon.com
Designed in USA
©Arkon Resources, Inc.
(SPHDMAGKIT)
(SP25MM17)
(SP-RM250)
(SPRM079)
® products near areas that intefere with operation
Continued on page 2
Need assistance?
Scan to email our
Arkon® customer
service team.
rev.050824