Omron WIRED REMOTE I-O System Manual page 57

Masters and Slaves
Switches
TEST
CONTINUE/STOP
CONTINUE/STOP Switch
Pressed to test the transmission line when the PC is in PROGRAM mode. Test
is repeatedly performed while button is held down. This switch is also pressed
to clear transmission errors.
Used to select whether or not transmission is to be STOP continued for trans-
mission errors or I/O bus errors at Slaves.
This switch is used to set either CONTINUE or STOP mode to designate re-
sponse to transmission errors. When a transmission error occurs, data trans-
mission to Slaves will continue in CONTINUE mode and stop in STOP mode.
Transmission errors for Masters include BCC errors, no-Slave-response er-
rors, and transmission line check errors.
CONTINUE Communications with Slaves continued for transmission er-
rors. Normal operation continued after error cleared.
STOP Communications with Slaves discontinued for transmission
errors. Refer to Section 5 Error Processing for recovery proce-
dure.
Section 4-1
CONTINUE
STOP
47