Advertisement
Rating/Performance
DC 2-wire Models
Item
Model
Sensing distance
Setting distance
Differential distance
Sensing object
Standard sensing object
Response frequency
Rated supply voltage
(operating voltage)
Leakage current
Switching capacity
Control
output
Residual voltage
Indicator lamp
Operating status
(with sensing object approaching)
Protective circuits
Ambient temperature
Ambient humidity
Temperature influence
Voltage influence
Insulation resistance
Dielectric strength
Vibration resistance
Shock resistance
Protective structure
Connection method
Weight (Packed state)
Case
Material
Sensing
surface
Accessories
* The response frequencies for DC switching are average values measured under the condition that the distance between each sensing object is twice as large as the
size of the sensing object and the sensing distance set is half of the maximum sensing distance.
D-54
5 mm ±10%
0 to 4 mm
10% max.
Ferrous metal(Sensitivity decreases with non-ferrous metals)
Iron, 18 x 18 x 1 mm
0.5 kHz
12 to 24 VDC (10 to 30 VDC), ripple (p-p): 10% max.
0.8 mA max.
3 to 100 mA
3.3 V max. (under load current of 100 mA with cable length of 2 m)
D1 models: Operation indicator (Red LED), Operation set indicator (Green LED)
D2 models: Operation indicator (Red LED)
D1 models: NO
D2 models: NC
Surge absorber, short-circuit protection
Operating/Storage: -25°C to 70°C (with no icing or condensation)
Operating/Storage: 35% to 95%RH (with no condensation)
±10% max. of sensing distance at 23°C within a temperature range of -25°C and 70°C
±2.5% max. of Sensing distance within a rated voltage range ±15%.
50 M
min. (at 500 VDC) between energized parts and case
1,000 VAC for 1 min between energized parts and case
10 to 55 Hz, 1.5 mm double amplitude for 2 hours each in X, Y, and Z directions
2
Destruction: 500 m/s
for 3 times each in X, Y, and Z directions
IEC60529 IP67
Pre-wired models (standard length: 2 m)
Approx. 45 g
Heat-resistant ABS resin
Instruction manual
TL-W5MD#
Inductive Sensors
Advertisement
