Omron H7E Manual page 29

Accessories (Order Separately) (Common)
■ New H7E (Except for PCB-mounting Counter)
The New H7E models are supplied with a mounting bracket (Y92F-34) and nut. Additionally, the Y92F-75/-76/-77B Flush Mounting Adapters shown
here allow the New H7E models to be fitted to existing panel cutouts.
Y92F-35 Compact Flush Mounting Bracket
Degree of protection (front): IP40 (not waterproof)
The Y92F-76 adapter can be used. The DIP switch of the H7E@-N
can be operated in mounted condition. Vibration resistance and
shock resistant are the same level as the H7E@-N series.
Y92F-75 Flush Mounting Adapter
for 26 45.3 Rectangular Cutout
Use mounting bracket supplied with the Counter
(Color: light gray)
Y92F-76 Flush Mounting Adapter
for 27.5 52.5 Rectangular Cutout
(Color: light gray)
Use the Y92F-76 together with the Y92F-35 Compact
Flush Mounting Bracket.
Y92F-77B Flush Mounting Adapter
for 24.8 48.8 Rectangular Cutout
Use mounting bracket supplied with the Counter
(Color: light gray)
47.6
26
R S T
31 24.2 22.2
50 38 24.2 22.2
R S T
28.8 24.2 22.2
Self-powered Totalizer
Single mounting
2.4 18.6 4
30 min.
+0.5
45
• The minimum mounting interval is 30 mm.
Note: An interval of 40 mm is recommended for easier wiring.
• Do not allow the ambient temperature of the H7E@-N to exceed the
specifications (55 C).
• Mounting is possible onto panels with a thickness of 1 to 5 mm.
Two 3.5 dia. mounting holes
4
45.2
48.2
63
72
Two 4.5 dia. countersunk holes
45.2 4
48.2
60
45.2 4
48.2
53.8
New H7E (Common)
Panel Cutout
Dense ounting
+1.0
0
+0.5
22.2
0
0
Panel Cutout
Two, M3
26
26
45.3
63
Panel Cutout
Two, M4
38 27.5
52.5
Panel cutout
24.8
48.8
Note: The mounting panel
thickness should be
between 1 and 5 mm.
+0.5
22.2
0
C-35