Omron GRT1-PNT - DATASHEET 2 Operation Manual page 69

Set-up the GRT1-PNT Configuration
Using the On-Line
Functions
Upload Button
1,2,3... 1 Select the SmartSlice I/O Unit in the I/O Configuration.
2 Press the Edit button below the I/O Configuration list. The appropriate
setting window will pop up.
Note 1 In order to download/upload settings for individual SmartSlice I/O Units, the DTM
has to be on-line with the physical GRT1-PNT Unit, i.e. it has to be able to establish
a connection with the device.
2 In the case of the GRT1-AD2 some parameter settings will affect the I/O Configura-
tion, i.e. it will change the I/O size for that particular SmartSlice I/O Unit. In that
case, the I/O Configuration for the PROFINET IO Controller Units needs to be (re-)
downloaded. If this is required, an appropriate warning window will pop up.
3 The configuration options and windows for individual SmartSlice I/O Units are
described in detail in the GRT1 Series SmartSlice I/O Units Operation Manual
(W455).
4 The GRT1-PNT Unit does not support the Output Hold/Clear settings for the
SmartSlice I/O Units in case of host communication/PROFINET IO fault (Idle
action). The Output Hold/Clear settings for SmartSlice bus fault (Fault action) is
supported.
In order to use the online functions of the GRT1-PNT DTM, be sure to connect
the Personal Computer directly to the ethernet network. The communication
will go directly to the GRT1-PNT unit, not through the IO Controller.
At the bottom of the GRT1-PNT DTM are four buttons which will be enabled
after the DTM has established communication with the physical device.
Switching to on-line must be done via the FDT Container. To switch to on-line,
perform the following steps in the configurator.
1,2,3... 1 In the Network view, right-click the GRT1-PNT.
2 From the context menu, which pops up, select the option Go Online.
The functions of the buttons are discussed below.
Pressing the Upload button will initiate an upload of all SmartSlice I/O
Information, i.e. I/O Configuration, Unit types and Unit parameters. From this
upload, the I/O Configuration in the Configuration list will be assembled.
Section 3-4
57