Graco Vis-Con 226-816 Instructions And Parts List

INSTRUCTIONS-PARTS LIST
This manual
contains
IMPORTANT
WARNINGS and INSTRUCTIONS
READ AND RETAIN FOR REFERENCE
IVIScositv-CONtroll
FLUID HEATER
3aw
psi
(207
bar) MAXIMUM WORKING PRESSURE
For reducing viscosity by heat where fluid permits.
Model 226-816, Series C, 120 Volt
M o d e l
226-819, Series C, 240 Volt
M o d e l s
226-816
a n d
226-819
are explosion-proof, and
approved by the Factory Mutual System and CSA
Not Approved by the Factory Mutual System or CSA
M o d e l
231-039
Series
A, 240 Volt
INDEX
Warnings
.....................................................
.2,
3
Typical Installation
..............................................
4
Installation
....................................................
4, 5
Operation
.........................................................
5
Service 7-10
Maintenance 6
Troubleshooting Guide
.....................................
7
Replacing the Indicator Lamp
.............................
8
Replacing the Indicator Lamp Socket
...................
8
If
Fluid Passages are Clogged
.............................
8
Replacing the Cover and Circuit Board
Assembly (Modela228816and 226-8191
..............
9
Replacing the Cover and Circuit Board
Pans Drawing (Models 228816 end 2258191 ..11
Assembly (Model 2310391; 10
Parts Drawing (Model
231-0391
.............................
12
Mounting Hole Layout
.;..
.13
Dimensional Drawing 13
Technical Data
.......................................
Back Page
How To Order Replacement Parts
...............
Back Page
Warranty
..............................................
Back Page
.....................................................
........................................................
.............................
.........
.........................................
................................. ..
G
307-363
Rev. F
ORAC0
SUPERSEDES E
Approved
Aluminum and Zinc Material Hazard
WARNING
fluids containing such solvents in this equipment. Such use could result in a
serious
chemical reac-
Never use 1,l.l-trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or
tion, with the possibility of explosion, which could cause death, serious bodily injury andlor substan-
tiel property damage.
Consult your fluid suppliers to ensure that the fluids being used are compatible with aluminum and
zinc parts.
GRACO INC. P.0. BOX 1441' MINNEAPOLIS, MN 55440-1444
@
COPYRIGHT 1961 GRACO INC.