Page 2
Mexico Importer: Bose de México, S. de R.L. de C.V. , Paseo de las Palmas 405-204, Lomas de • Keep the product away from fire and heat sources. Do not place naked flame sources, Chapultepec, 11000 México, D.F.
Technical Specifications Important Installation Information It is the installer’s responsibility to ensure installation of For additional specifications, see the DesignMax DM8C technical the loudspeakers and mounting system is performed in data sheet at accordance with all applicable codes, including local building codes and regulations.
3/8-inch single in 3/8-inch duplex in/loop Wiring the Loudspeaker Wire Gauge The DesignMax DM8C loudspeaker is designed to work with 18 AWG (0.8 mm ) to 14 AWG (2.5 mm ) size wire only. Connection Diagrams Expose six millimeters (1/4 inch) of bare wire to attach to the terminals.
Align the rails and insert the tabs into the slots. Bose Professional recommends using (1) a safety wire, (2) a safety Pull the rails outward to secure them together. cable, or (3) a threaded rod as a secondary securing mechanism.
Tighten the anchor arm screws to secure the loudspeaker. If using a power drill, set to a low torque setting. WARNING: Over-tightening the screws may result in damage to the anchor attachment point or the ceiling, which could lead to a falling hazard. 6 • English DesignMax DM8C • Installation Guide...
NFPA 70, National Electrical Code, 2017, Article 300-22(c) NFPA 90-A, 2015, Installation of Air Conditioning and Ventilation Systems, Paragraph 4.3.11.2.6.5 The DesignMax DM8C loudspeaker has been designed to the requirements defined in the following European regulatory specification for combination systems: Tested to IEC60268-5, 2007 Installation Guide •...
Need help?
Do you have a question about the DesignMax DM8C and is the answer not in the manual?
Questions and answers