Drawing Out; Wiring Precautions - Omron E5 R Selection Manual

Drawing Out

Although the Unit does not have to be drawn out for standard operation, it can be drawn out for maintenance if necessary.
Removing the Front Panel
A flat-bladed screwdriver (shown below) is required to remove the front panel.
1. Insert the screwdriver in the holes (2) at the top and bottom of the
front panel and unfasten the hooks.
2. Insert the screwdriver in the gap between the front panel and the
rear case and pull out the front panel a little. Then, hold the top
and bottom of the front panel and pull in the direction of the arrow
(below) to remove.
(1)
(2)
(1)

Wiring Precautions

• Prevent the influence of noise by separating input lines and power
lines.
• Use crimp terminals.
• Tighten the terminal screws using a torque between 0.40 and
0.56 N·m.
• Use M3 crimp terminals with the following dimensions.
38
Digital Controllers
F lat-b laded Sc rew driv er
(Un its : mm )
0.4 2.0
5.8 mm max.
5.8 mm max.
E5AR/E5ER