Level 1 Mode; Level 2 Mode - Omron E5AK Datasheet

Level 1 Mode

AT Execute/Cancel
Set Point 0
Used with multi-SP function.
Set Point 1
Used with multi-SP function.
Set Point 2
Used with multi-SP function.
Set Point 3
Used with multi-SP function.
Alarm Value 1
Available only when the alarm output 1 is assigned.
Alarm Value 2
Available only when the alarm output 2 is assigned.
Alarm Value 3
Available only when the alarm output 3 is assigned.
Proportional Band
Available if the Controller is in advanced PID control.
Integral Time
Available if the Controller is in advanced PID control.
Derivative Time
Available if the Controller is in advanced PID control.
For heating/cooling control
Cooling Coefficient
Used with the Controller is in
heating and cooling control.
Dead Band
Used with the Controller is in
heating and cooling control.
Manual Reset Value
Available when the integral time parameter
of the Controller in standard control is "0".
Hysteresis (Heat)
Available when the Controller is in
ON/OFF control.
For heating/cooling control
Hysteresis (Cool)
Available when the Controller is in
ON/OFF control
Control Period (Heat)
Available when the Controller has a relay or
voltage output, or is in advanced PID control.
For heating/cooling control
Control Period (Cool)
Available when the Controller has a relay
or voltage output, or is in advanced PID
control.
Heater Current Monitor
Available when the heater
Current value burnout alarm is assigned.
Heater Burnout Detection
Available when the heater
burnout alarm is assigned.
26
Digital Controller
For E5@K-PRR2
Position-
proportional
dead band
E5AK/E5EK

Level 2 Mode

Remote/Local
Used for the
communications function.
SP Mode
SP Ramp Time Unit
SP Ramp Set Value
LBA Detection Time
Available when the LBA (loop break
alarm) is assigned as an output.
Unavailable to the E5@K-PRR2.
MV at Stop
MV at PV Error
MV Upper Limit
Unavailable to the
E5@K-PRR2.
MV Lower Limit
Unavailable to the
E5@K-PRR2.
MV Change Rate Limit
Input Digital Filter
For E5@K-PRR2
Open/Close hysteresis
Alarm 1 Hysteresis
Available only when the alarm
output 1 is assigned.
Alarm 2 Hysteresis
Available only when the alarm
output 2 is assigned.
Alarm 3 Hysteresis
Available only when the alarm
output 3 is assigned.
Input Shift Upper Limit
Available if the input type is a
thermocouple or platinum resistance
thermometer.
Input Shift Lower Limit
Available if the input type is a
thermocouple or platinum resistance
thermometer.
(See Input Shift)